Draper LightBloc FlexShade Инструкции по установке и эксплуатации - Страница 3

Просмотреть онлайн или скачать pdf Инструкции по установке и эксплуатации для Внутренняя отделка Draper LightBloc FlexShade. Draper LightBloc FlexShade 8 страниц.

Печатать страницу

LightBloc FlexShade

Section 1 - Preparation for Installation

Caution: Before mounting shades, verify measurements on package label with shade.

Please Note: Installer is responsible for selecting mounting hardware appropriate for site conditions.

1. FOR ALL: Open cartons lengthwise. Remove all pieces from carton. If shade has a detachable crank handle, remove universal

joint and shaft/bracket assembly by removing 2 screws from bottom of endcap

Wall/Ceiling

Please Note: If unit is motorized with a crank override, skip this step. Roller

assembly and headbox assembly must be installed as a unit — the roller

assembly cannot be removed without completely disassembling headbox.)

FOR CRANK OR MOTORIZED UNITS: Remove black plastic retainer clip from

idler end of roller and retainer clips from motor studs. Save these clips to replace

when re-assembling. Lift idler out of bracket Depress spring-loaded pin by pressing

roller toward pin end endcap until clutch hooks are free from operator endcap.

Remove roller assembly from headbox.

FOR BEAD CHAIN CLUTCH UNITS: Lift up on clutch end so that clutch hooks

can disengage from operator endcap. Depress spring-loaded pin by pressing roller

toward pin end endcap until clutch hooks are free from operator endcap. Remove

roller assembly from headbox.

Please Note: It may be necessary to locate and drill a hole for conduit connector

(Conduit connector is not supplied) (Fig.

FOR ALL: Verify dimensions of opening and refer to order for overall dimensions

of unit. Determine location of headbox directly above and centered on opening.

It is critical that headbox is installed absolutely level

needed). Install headbox assembly using appropriate fasteners through pre-drilled

holes in endcaps, then drill through cover for wall/ceiling mounting

Figure 4

Figure 2

Pocket

4).

(use shims and caulking if

Figure 5

Wall/Ceiling

(face)

Existing Pocket

(Fig.

1). Save universal joint & screws.

2. FOR ALL: Remove face cover from

headbox by pulling down and out on

bottom edge of cover near endcaps. It

(Fig.

will snap off

installation, remove screws at endcaps.

Bottom of cover box snaps down and

off at endcaps then slides out of slot in

(Fig.

cover box

3. FOR ALL: Remove roller assembly

from headbox.

Figure 3:

Idler End

Idler

Endcap

Retainer Clip

Be sure retainer clip is installed.

Idler

Endcap

(Fig.

5).

Retainer Clip

Be sure retainer clip is installed.

Idler

Endcap

or Jamb Mount

Retainer Clip

2). If this is a pocket

Crank

Handle

2).

Operator End

Motorized

Idler End

of Roller

Crank

Idler End

of Roller

Bead Chain Clutch

Idler End

of Roller

Idler

Endcap

First

Remove

Screw

Then

Remove

Slide

Route Bead Chain

Through

Replace

Chain Guide and

Slide & Screw

Attach Cover

page 3 of 8

CRANK ASSEMBLY

Crank Endcap

& Assembly

Figure 1

Clutch

Endcap

20lb Clutch

Clutch

Endcap