Draper LightBloc Zip Руководство по установке - Страница 2
Просмотреть онлайн или скачать pdf Руководство по установке для Внутренняя отделка Draper LightBloc Zip. Draper LightBloc Zip 6 страниц.
Также для Draper LightBloc Zip: Руководство по установке (6 страниц)
Печатать страницу
LightBloc
Zip by Draper
™
Preparation
1 Use 3mm Hex Wrench to remove Screws from Side Channels and set aside.
2 Remove Side Channel Covers. Please Note: Do NOT remove the Bottom Caps from Side Channels.
3 For jamb mounting, also remove the Fabric Retainer Strip and set aside.
4 Drill through Side Channels at desired mounting points (See Fig. 7).
5 Mark wall or jamb and drill small pilot holes in mounting surface.
S i
C h
C h
d e
a n
n e
l
Attaching Side Channels to Mounted Headbox
6 Insert Side-Channel Guide and Fabric Retainers into Side Channels (See Fig. 8).
Please Note: Make sure Fabric Retainers go back into the Side Channels
with Fabric Guide at top of Side Channels and angled leg oriented
towards the back (see Fig. 8).
Insert
Side
Channel
Guide
Figure (8)
S i
d e
C h
a n
n e
l
7 Insert "Zipper" on one side of the Hem Bar into the fabric retainer in the
Side Channels (See Fig. 9).
8 With "Zipper" engaged in Fabric Retainer, insert side channel guide into
bottom of the endcap (See Fig. 10).
9 Attach side channel to the mounting surface using appropriate fasteners.
*** IMPORTANT: Side Channels MUST be installed parallel with a
tolerance of +/- 1/8" (3mm).
10 Repeat Steps 7 - 9 for the other Side Channel.
11 Re-attach Side Channels Covers using the screws removed in Step 1.
Please Note:
Failure to use provided fasteners to re-attach side channel covers may
result in product failure in high wind.
Mounting Side Channels
S i
d e
a n
n e
l
Angled leg of FABRIC
RETAINER STRIP must
be oriented towards back
U P
Side Channel Cross Section
www.draperinc.com
Figure (7)
Neoprene cushions
on the retainer strip
(shown in black)
ARE NOT TO
BE REMOVED.
If they come off,
replace using
double-sided tape.
Wall Mounting
Wall Mounting
See Step 8
See Step 8
Figure 10
Figure 10
for detail
for detail
S i
C h
d e
a n
n e
l
Figure (10)
End Cap
Side
Channel
Guide
(765) 987-7999
Page 2 of 6
J a
m b
P i
M o
l o t
u n
H o
J a
t
m b
l e
P i
M o
l o t
u n
H o
t
l e
Jamb Mounting
Figure (9)
¼"
Jamb Mounting
of the Zipper must
be visible on BOTH
sides of the Hembar.
ZIPPER
Side
Channel
Guide
HEMBAR
FABRIC
RETAINER
S i
STRIP
d e
C h
a n
n e
l
End Cap
Side Channel
Side
Guide Properly
Channel
Engaged
in Headbox
In
S
C
G