BD Diesel Performance X-Monitor 1087000 Руководство по установке - Страница 7
Просмотреть онлайн или скачать pdf Руководство по установке для Измерительные приборы BD Diesel Performance X-Monitor 1087000. BD Diesel Performance X-Monitor 1087000 13 страниц. Digital pyro & boost pressure monitor
Печатать страницу6 November 2006
Boost Pressure Hose
Attach one end of the supplied 6 ft piece of hose onto the open port on the supplied
Boost Fitting Assembly and route it through the firewall by piercing a large rubber
grommet.
Route the hose into the cab under the dash taking care not to kink the tubing and to
keep it away from hot and moving parts.
Push this end of the hose into the
supplied Boost-Module Connector
Fitting Assembly (see diagram to
the right) and connect rubber hose
of the supplies fitting onto the
pressure sensor barb on the back of
control box. The module should
be mounted with the barb pointed
downward
to
condensation in the boost line
from collecting in the module.
Power & Ground connections
Locate a switched 12-volt power source under the dash and install the fused Red
wire to it. Plug the Red wire into the "+12v" terminal on the module.
Install the ground loop of the Black wire to a good ground and plug into the "GND"
Terminal on the module.
NOTE: A good power and grounding sources are paramount to proper operation of
the X Monitor. Improper sources and can cause faulty or erroneous readings or
component failure. This will void warranty.
Ship: 88 – 446 Harrison St, Sumas, WA 98295
BD X-Monitor (Pyro & Boost Only)
prevent
any
BD Engine Brake Inc
A10 – 33733 King Rd, Abbotsford, BC, Canada V2S 7M9
Ph: 604.853.6096 Fax: 604.853.8749 Internet: www.bd-power.com
Mail: PO Box 231, Sumas, WA 98295
7