Electrolux 506063 Руководство - Страница 24
Просмотреть онлайн или скачать pdf Руководство для Стиральная машина Electrolux 506063. Electrolux 506063 28 страниц.
![Electrolux 506063 Руководство](/uploads/products/server2/1380309/1380309.png)
J
J1
Correct use
Our appliances are designed and optimized in order to
obtain high performance and efficiency. This equip-
ment must only be used for its expressly designed pur-
pose, i.e. washing items with water and specific
detergents. Any other use is to be deemed improper.
J2
Characteristics of personnel enabled to
operate on the appliance
Operator qualified for normal use must have at least:
•
knowledge of the technology and specific experi-
ence in operating the appliance;
•
adequate general basic education and technical
knowledge for reading and understanding the con-
tents of the manual,
•
the capacity for a correct interpretation of the draw-
ings, signs and pictograms;
•
sufficient technical knowledge for safely performing
his duties as specified in the manual;
•
knowledge of the regulations on work hygiene and
safety.
In the event of a significant anomaly (e.g. short circuits,
wires coming out of the terminal block, motor break-
downs, worn electrical cable sheathing, etc.) the oper-
ator qualified for normal appliance use must:
•
immediately deactivate the appliance by turning the
main switch to "O" ;
•
close the appliance water supply by shutting off the
water.
J3
First use
Carry out a couple of cycles without items to flush out
any industrial grease which has remained in the tank
and piping.
J4
Daily activation of appliance
•
Make sure the filters and the arms are correctly fit-
ted according to that indicated in par. H1.2 "Check
the positioning of tank components" and F8
"Energy control arrangement".
•
Open the water supply cocks.
•
Activate the main switch by turning it to position "I".
•
Open the door and check that all the components
are in their correct position.
•
Close the door.
•
Switch on the appliance by pressing the button "A".
The button "A" lights up (Table 2 "Control panel"), indi-
cating that the appliance is powered and that water is
being introduced and heated.
The word "FILL" is shown on the display during the
entire filling and heating stage:
26
NORMAL APPLIANCE USE
FIL
Warning, this appliance does the first tank filling
through several consecutive hot rinse cycles, while the
display shows the message FILL (flowing).
This system let save up to 30% of time than traditional
models.
If the door is opened during this stage the message
"CLOSE" will appear on the display:
CLO
The filling and heating stage has finished when the
display shows the tank temperature:
55
To display the boiler temperature during heating of the
tank, open the door and press the button "G" (Table 2
"Control panel").
J5
Wash cycles
The wash cycle includes a wash with hot water and
detergent at a temperature of at least 55°C/ 131°F and
a rinse with hot water and rinse aid (min. 82°C / min.
180°F).
Table of times
Standard cycle time with supply water at 50 °C :
I
EPPW
3 min
A device lengthens the cycle time if the water in the
boiler has not reached the minimum temperature for
correct rinsing.
The cycle times and the temperature may be
personalised (e.g. increase of the rinse time and
temperature).
The cycle times should only be set by a specialised
technician.
J6
Operation
The filling and heating stage has finished when the
display shows the tank temperature:
55
II
III
IV
6 min
9 min
INFINITE