Bosch HBA73A 1 Series Руководство по эксплуатации - Страница 10

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Печь Bosch HBA73A 1 Series. Bosch HBA73A 1 Series 24 страницы.

Bosch HBA73A 1 Series Руководство по эксплуатации
ã=
Significant health risks!
Do not place non-stick baking tins or trays in the oven during
self-cleaning. The intense heat removes the non-stick surface
and creates toxic gases.

Setting

Once the cleaning level has been selected, set the oven.
Select the Self-cleaning
1.
knob.
Select the cleaning level with the temperature control knob.
2.
The time when the cleaning will be finished is displayed and
the
p
symbol will be shown in square brackets. Self-cleaning
starts within a few seconds. The cleaning time is displayed and
the
r
symbol appears in square brackets. The
switches off.
The oven door locks shortly after the function has started. The
display panel shows the
L
turns off can the oven door be opened again.
Self-cleaning has ended.
The display panel will show
Turn the function control knob to the zero setting. The oven
switches off. The oven door can be opened again when the
symbol on the display panel turns off.

Care and cleaning

If cleaned and properly cared for, your oven will keep its bright
appearance and operating performance for many years to
come. Advice on how to care for and clean your oven is
provided below.
Notes
Different colours may be seen in your front panel due to the
various materials used in its manufacture, such as glass,
plastic and metal.
Dark patches in the door's glass panel may seem to be dirt
but they are in fact reflections from the oven light.
Enamel burns at very high temperatures. This may cause
slight discolouration. This is normal and does not affect the
oven's operation. The edges of thin baking trays may not be
completely enamelled. They may therefore feel slightly rough,
although their corrosive protection will be unaffected.

Cleaning products

Follow the indications provided in the table to avoid damaging
the various oven surfaces by using unsuitable cleaning
products. Do not use
abrasive or acidic cleaning products
strong products containing alcohol
scourers or hard sponges
high-pressure or steam cleaners.
Wash new dishcloths thoroughly before use.
10
function with the function control
q
p
symbol
symbol. Only when the
L
‹‹
:
‹‹
. The oven will stop heating.
Changing the cleaning level
The cleaning level cannot be changed once it has started.
Stopping the self-cleaning
Turn the function control knob to the zero setting. The oven
switches off. The oven door can be opened again when the
symbol on the display panel turns off.
Delaying the end time
The oven can be set to end the self-cleaning at a specific time.
Self-cleaning can therefore be programmed at night for
example, leaving the oven free for use during the day.
Programme as described in point 1 and 2. Before cleaning
starts, put back the time with the
The oven is set to standby. The time when the cleaning will be
finished is displayed and the
brackets. When the cleaning starts, the cooking time is
displayed and the
symbol
The
symbol switches off.
p

After using the self-clean function

Once the inside of the oven has cooled, clean the ash remains
using a damp cloth.
L
Zone
Front panel
Stainless steel
Glass panel
Display
Glass panels on oven
door
Door covering
or
buttons.
@
A
symbol will be shown in square
p
symbol appears in square brackets.
r
Cleaning products
Hot water and a little soap:
Clean with a dishcloth and dry with a
soft cloth. Do not use a glass clean-
ing product or a glass scraper.
Hot water and a little soap:
Clean with a dishcloth and dry with a
soft cloth. Immediately remove any
water marks, grease, cornflower or
egg white stains since corrosion
could occur underneath these marks
or stains.
Special products for the care of
stainless steel which are suitable for
hot surfaces may be obtained from
Technical Assistance Service cen-
tres and specialist retail outlets. Use
a very fine soft cloth to apply the
cleaning product.
Glass cleaning products:
Clean with a soft cloth. Do not use a
glass scraper.
Glass cleaning products:
Clean with a soft cloth. Do not use
alcohol, vinegar or other abrasive or
acidic cleaning products.
Glass cleaning products:
Clean with a soft cloth. Do not use a
glass scraper.
Only use products specially for
cleaning stainless steel (these can
be obtained from the Technical
Assistance Service or from specialist
shops). Follow the manufacturer's
instructions.
L