AirStage UTY-RSKY Руководство по установке - Страница 7
Просмотреть онлайн или скачать pdf Руководство по установке для Пульт дистанционного управления AirStage UTY-RSKY. AirStage UTY-RSKY 9 страниц. Simple remote controller
Также для AirStage UTY-RSKY: Руководство по эксплуатации (2 страниц), Руководство по эксплуатации (2 страниц)
Печатать страницу
7. TURNING ON THE POWER
O D S
Recheck the wiring. Incorrect wiring will cause trouble.
(1) Check the remote controller wiring and DIP switch settings.
(2) Install the front case.
* When installing the front case, connect the connector to the front case
(in 5 INSTALLING THE REMOTE CONTROLLER).
(3) Check the indoor and outdoor unit wiring and PC board switch settings,
and then turn on the indoor and outdoor units.
After "
" has fl ashed on the set temperature indicator for several
second, the
mark will be displayed in the center of the remote
controller display.
*
For the wiring and PC board switch settings method, refer to the
installation manual for the indoor unit and outdoor unit.
8. ADDRESS SETTING
M
Address setting method of indoor unit can be selected from 3 options (outdoor
unit, indoor unit and remote controller).
Refer to the installation manual of outdoor unit or indoor unit when set up
from the outdoor unit or the indoor unit.
•
"Indoor unit address" and "Refrigerant circuit address" can be set using
the remote controller.
•
This function can be set in all indoor units when the remote controller is
connected.
•
"Remote controller address" cannot be set in this function. Ensure to set
with the Rotary switch of PC board of the indoor unit.
•
When setting the address of indoor unit, refer to installation manual of
indoor unit.
•
When setting the address of outdoor unit automatically, refer to installation
manual of outdoor unit.
•
When setting the address with a remote controller, refer to installation
manual of indoor unit for setting details of indoor unit.
Switching selection of address setting mode
(1) Press the " ▲" button, "
▼" button and "
seconds simultaneously. Then shift to Address setting mode.
(2) Press the " ▲" button or " ▼" button and select the Remote controller
address (Select the relevant indoor unit). Then press the "
CAUTION
" button for more than 5
Address setting mode initial indicator
" button.
Remote controller address
Ex. When Remote controller
address "01" is selected.
Indoor unit address setting
(3) "Address code" indicator blinks. Then display Address code "01" by
pressing the " ▲" button or " ▼" button.
(4) When the "Address data" blinks by pressing the "
Indoor unit address data by pressing the " ▲" button or " ▼" button.
(Range of setting is 00-63.)
(5) Fix the Indoor unit address data by pressing the "
is transferred to the indoor unit).
PROHIBITED
•
When Indoor unit address
data is not set in the indoor
unit. (-- is displayed).
•
Set the Indoor unit address
data again as per procedures
(3)-(5) above.
Address code
" button set the
Indoor unit address data
Ex. When Indoor unit address
data "12" is selected.
" button. (Data
GOOD
When Indoor unit address data is
set in the indoor unit properly.
En-6