Bosch HBC34D554B Руководство по эксплуатации - Страница 20
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Печь Bosch HBC34D554B. Bosch HBC34D554B 32 страницы. Combination steam oven
Также для Bosch HBC34D554B: Руководство по установке (16 страниц), Руководство по эксплуатации (32 страниц)
Печатать страницу
Problem
and
:
light up in the display
0
‹‹
‹‹
is shown in the display
"‰
The
Ë
indicator appears even though the
water tank is full
The
indicator appears even though the
Ë
water tank is not yet empty, or the water
tank is empty but the
indicator does not
Ë
appear
The water tank empties for no discernible
reason. The evaporator dish is overflowing
The evaporator dish has boiled empty
even though the water tank is full.
The
Ë
indicator appears
There is a "pop" noise during cooking
When you cook with steam, a lot of steam
is created
When cooking with steam, a lot of steam is
created again
Steam escapes from the ventilation slots
during cooking
The appliance is not producing steam
properly
Error message
"‹‚‚
appears in the dis-
play
An
... error message appears in the dis-
"
play
The appliance is not heating The colon
flashes in the display
Replacing the cooking compartment bulb
Heat-resistant 230 V/25 W halogen bulbs with seals are
available from the after-sales service. Please specify the E
number and FD number of your appliance.
:
Risk of burns!
Allow the cooking compartment and cooking compartment light
to cool before changing the bulb.
Always use a dry cloth to remove a new halogen bulb from the
packaging, otherwise it will not last as long.
Switch off the fuse in the fuse box or unplug at the mains.
1.
Turn the cover anti-clockwise to remove.
2.
Remove the bulb and replace with a bulb of the same type.
3.
Slide the new seals and the clamping ring onto the glass
4.
cover in the right order.
20
Possible cause
Power cut
The automatic safety switch-off is active
The water tank has not been inserted
properly
The detection system is not working
The water tank is dirty. The mobile water
level indicators are jammed
The water tank was not closed properly
The tank lid seal is dirty
The seal in the tank cover is defective
The water tank has not been inserted
properly
The feed line is blocked
The appliance has not been used for at
least 2 days and the water tank is full
Cold/warm effect with frozen food, caused
by the steam
The appliance is being automatically cali-
brated
The appliance is unable to calibrate itself
automatically if cooking times are too
short
Limescale has formed in the appliance
A button was pressed for too long or is
jammed
Technical fault
A button combination was actuated
Screw the glass cover with the seals back on again.
5.
Connect the appliance to the mains and reset the clock.
6.
Never operate the appliance without the glass cover and seals.
Replacing the glass cover or seals
Any damaged glass cover or seals must be replaced. Please
provide the after-sales service with the E number and FD
number of your appliance.
Notes/remedy
Reset the clock time (see section: "Time-
setting options")
Press any button.
Slide in the water tank until it locks into
place.
Call the after-sales service
Shake and clean the water tank. If the
parts cannot be released, obtain a new
water tank from the after-sales service.
Close the lid until you feel it engage.
Clean the seal
Obtain a new water tank from the after-
sales service
Slide in the water tank until it locks into
place
Descale the appliance. Check whether the
water hardness range is set correctly
Empty and clean the water tank. Always
empty the water tank after cooking
This is normal
This is normal
Reset the appliance to the factory settings
(see Basic settings section). Then start
Steam at 100 °C for 20 minutes
This is normal
Start the descaling programme.
Press the
0
button to clear the fault mes-
sage. Press all of the buttons individually
and check if they are clean
Press the
button to delete the error
0
message. Reset the clock if required. If the
error message appears again, call the
after-sales service
Set the Steam operating mode to 35 °C,
then press and hold the
D
audible signal sounds. Press the
ton again briefly
button until an
D
but-