Electrolux EW 1010 F Буклет с инструкциями - Страница 4
Просмотреть онлайн или скачать pdf Буклет с инструкциями для Стиральная машина Electrolux EW 1010 F. Electrolux EW 1010 F 14 страниц.
Печатать страницу
INSTALLATION
Unpacking
All transit bolts and packing must be removed
before
using the machine.
You are advised to keep all packing for re-use in case
you move
house
and the machine
has to be
transported again.
Proceed as follows:
Using a spanner remove
the screw on the right at
the rear of the machine.
Carefully lay the machine
on its back making sure
that the hoses
are
not
squashed.
Place between
machine
and bottom
one
of the
polystyrene angle pack-
ings.
PO234
Remove the polystyrene panel from underneath the
machine. There is no need to keep this panel.
Release
the two polythene
bags by removing
the
adhesive strip.
Carefully remove the right polythene bag (1) by pulling
it towards the centre of the machine.
Repeat the
operation for the left polythene bag (2).
Set the machine upright and remove the remaining
two screws on the back.
Remove the three plastic pins from the holes where
the screws were previously fitted.
Plug the holes with the plugs which you can find on
the back of the machine.
Positioning
Position the machine on a firm level surface.
The
machine
must
not touch
the wall or other
furniture.
It is assumed that the tap, drainage point and socket
are within easy reach of the machine hoses and power
supply cable. If not, you are advised to call your fitter
in order to move the tap and/or drainage point and/or
socket.
Water inlet
Connect the water inlet hose to a tap with a %4" gas
thread spout after fitting the filter supplied with the
machine.
Although the machine is provided with its own aerator,
your local water board may require the machine to be
connected to a ventilated tap. If you know that the
mains water supply pressure is often very high, fit a
34" 23x4x4 mm reducer at the joint between the water
inlet hose and the washing machine. The inlet hose
must not be extended. If it is too short and you do not
wish to move
the tap, replace it completely with a
longer high pressure hose specifically designed to
solve problems of this type.
&
|
S
pawns
ri
The other end of the inlet hose connected to the
machine can be turned in any direction. Simply loosen
the fitting, rotate the hose and retighten.