Electrolux EW 1035 F Буклет с инструкциями - Страница 19
Просмотреть онлайн или скачать pdf Буклет с инструкциями для Стиральная машина Electrolux EW 1035 F. Electrolux EW 1035 F 27 страниц.
Также для Electrolux EW 1035 F: Буклет с инструкциями (22 страниц), Буклет с инструкциями (25 страниц)
Печатать страницу
If it is necessary to drain the water in order to change
the programme in progress, proceed as follows:
• turn the programme selector dial to «O»;
• select programme
;
• press the START/PAUSE
When the water has been drained, the display shows
a blinking zero and the light
You may now select a new programme and press
the START/PAUSE button
12. Interrupting a programme
Depress the START/PAUSE button
programme which is running, the
corresponding light starts to flash. Depress the same
button again to restart the programme.
13. Cancelling a programme
Turn the selector dial to «O» to cancel a programme
which is running. Now you can select a new
programme.
14.How to open the door after the
programme has started
First set the machine to PAUSE by pressing the
START/PAUSE button
If the door does not open, this means that the
machine is already heating, that the water level is
above the bottom edge of the door or that the drum
is turning.
If you cannot open the door but you need to open it
you have to switch the machine off turning the
selector dial to «O» . After about 3 minutes the door
can be opened (pay attention to the water level and
temperature!). To restart the programme switch on
the machine and select again the desired
programme and options.
button again.
light on.
to start it.
to interrupt a
.
15. At the end of the programme
The washing machine stops automatically.
If the Rinse hold
option has been selected, the
door is blocked, the light of the START/PAUSE button
goes off,
and
water must be drained before opening the door. The
display shows a flashing zero.
There are 2 possibilities to empty out water:
• Select programme
The water is emptied out without spinning.
• Select programme
speed by means of the relevant button and then
depress the START/PAUSE button
is emptied out and the laundry is spun at the
selected spin speed.
Attention! Before selecting programme
and
the selector dial has to be
positioned on 0 (cancelling).
Turn the programme selector dial to Reset «O» to
switch the machine off.
Remove the laundry from the drum and carefully
check that the drum is empty so as to avoid any
forgotten items being damaged in a subsequent
wash (e.g. shrinking) or their colour running into a
load of whites.
If you do not intend to carry out another wash, close
the water tap.
Leave the door open to prevent the formation of
mildew and unpleasant smells.
19
remain lit, to indicate that the
(draining):
or
. Select the spin
. The water
,