Drayton 13619 Руководство пользователя - Страница 2

Просмотреть онлайн или скачать pdf Руководство пользователя для Термостат Drayton 13619. Drayton 13619 2 страницы. Digistat+ cf rf cylinder thermostat
Также для Drayton 13619: Руководство по установке (16 страниц)

Печатать страницу

the Digistat+C RF unit.

Proper Battery Recycling

Electronic devices and batteries, rechargeable or not, should not be

the Digistat+C RF unit are

disposed of into ordinary household waste. Instead, they must be

recycled properly to protect the environment and cut down the waste

of precious resources. Your local waste management authority can

supply details concerning the proper disposal of batteries.

the Digistat+C RF

In compliance with the EU Directive 2006/66/EC, the button cell

battery located on the printed circuit board inside this product, can be

the Digistat+C RF

removed at the end of product life, by professional personnel only.

The hot water can be manually switched on and off by using the

'Boost 1 Hr' button on the SCR in a fault situation, even though

the red LED will stay on until a satisfactory signal is reinstated.

When the hot water is turned on by pressing the 'Boost 1 Hr'

button, it will time out after 1 hour and return to OFF.

Signal Strength

Before fixing the Digistat+C RF to the wall it is recommended to first

check the signal strength from that location.

To do this, remove the batteries, press and hold the 'set' button whilst

refitting the batteries, keep the 'set' button held and after a few

seconds the display will show 'rF' which indicates that the Digistat+C RF

is continuously sending an OFF signal to the SCR (receiver). Leave the

Digistat+C RF in position and return to view the SCR. If the red LED is

continuously flashing, this indicates a good signal. If the red LED is not

flashing, this indicates a poor signal and you need to reposition the

Digistat+C RF until the red LED is flashing.

When the signal strength has been confirmed remove the batteries to

cancel the test and follow the installation instructions.

Unclip the housing to show the terminal block. First, connect a 2-core

cable to the Digistat+C RF transmitter, cut to the required length to

reach the sensor position. Connect to the sensor in the position shown

and fold wires back through the cable grip & out through the cable

entry, re-assemble the housing.

of walls between the Digistat +C RF and SCR.

+0/-8

Pollution Degree:

Software Class:

Energy Class:

I = 1% (According to EU 811/2013,

812/2013, 813/2013, 814/2013)

230V a.c.

24V a.c./d.c.

Temperature Range:

40°C to 70°C

Mounting:

Industry Standard Wallplate

Pollution Degree:

Software Class:

Rated Impulse Voltage:

2.5Kv

Ball Pressure Test:

75°C

(BS7671).

Relevant EC Directives:

2006/95/EC Low Voltage Directive

2004/108/EC Electromagnetic Compatibility

Directive

1999/5/EC R&TTE Directive

2006/66/EC Battery Directive

2011/65/EU RoHS Directive

Applied Standards:

EN60730-1; EN60730-2-9

ETSI EN 300 220-3, ETSI EN 301 489-3