Anchor AN-130 Руководство пользователя - Страница 4

Просмотреть онлайн или скачать pdf Руководство пользователя для Динамики Anchor AN-130. Anchor AN-130 4 страницы. Portable public address sound system
Также для Anchor AN-130: Технические характеристики (1 страниц), Руководство пользователя (8 страниц), Брошюра и технические характеристики (2 страниц), Каталог (2 страниц)

Печатать страницу

BASIC SYSTEM OPERATION

The AN-130 monitor is used to amplify the signal from a

microphone, electronic musical instrument or line-level sources

(cassette, CD, VCR, etc).

You'll need a connection cable and an AC outlet.

1. Place the AN-130 in desired location

2. Set volume control on front of speaker to minimum

3. Plug the power cord into a grounded 115 volt outlet

(220 volt outlet for export model)

4. Plug a microphone into the MIC input jack, or an audio

source into a LINE IN jack

5. Turn the power switch on the rear panel "ON"

(red LED on front panel should light)

6. Adjust the volume, bass & treble controls to desired levels

IMPORTANT: To avoid feedback, do not position

a microphone in front of speaker.

PROBLEMS? Consult the troubleshooting section

on the back page of this manual.

CAUTION: ALWAYS use shielded audio cables on

input connections to prevent interference.

NOTE: For UHF Wireless microphones

& transmitters see page 6.

REMOTE-130 - Wireless Remote Control

Controls volume level and mute for the AN-130RC.

MIC-90P - Handheld Microphone

Anchor's dynamic, balanced, low impedance micro-

phone with a unidirectional pick-up pattern. It has a

on/off switch and comes with a 20' cable and mic clip.

SS-250 - Speaker Stand

Adjustable stand made of black, anodized aluminum.

LINE IN

The line-level RCA input jacks may be used with audio sources such as computers, VCR's, and

cassette tape or compact disc players. The inputs may be used for two separate sources, or

they may be used to sum L+R stereo outputs to a mono signal without the need for adapters.

MIC IN

An unbalanced, low impedance

microphone input is for use with

the MIC-90P or other mics that

have a 1/4" phone plug.

AN-130 ACCESSORIES

MSB-201 - Combo Mic/Speaker Stand

Floor stand w/ 33" adjustable boom. Speaker stand

when combined w/ SB-1 mounting bracket.

HS-1 - Carry Handle

Convenient attachable handle for AN-130.

HC-1550 - Hard Case

Traveling hard case, holds up to two AN-130's,

two mics & accessories.

LINE OUT

The unbalanced Line-out provides a combined signal of all inputs

being used. You can use this function to record your presentation

or to "daisy chain" another powered sound system to the AN-130

for greater crowd coverage.

Note: This output is post source level; any volume fluctuations for a

specific input will affect the output signal level at this output.

HC-1610B - Hard Case

Projector Protector hard case - holds projector,

AN-130 and mic.

CC-100 - Carry Bag

Cordura nylon bag w/ storage compartment.

SB-1 - Swivel Stand Mounting Bracket

Mounts the AN-130 to a wall, ceiling or on a speaker

stand. Spekaer stand adapter included.

POWER SWITCH

AN-130

CONTROL PANEL

Model Shown: AN-130U1

POWER CORD

NOTE: SEE PAGE 6

FOR WIRELESS RECEIVER

INSTRUCTIONS

SB-3 - Swivel Wall Mounting Bracket

Mounts the AN-130 to the wall or ceiling.

SB-360 - Swivel (360

) Wall Mounting Bracket

Mounts the AN-130 to the wall or ceiling.

RM-1 / RM-12 - Single / Dual Rackmount Kits

Mounts AN-130 monitors in a standard equipment

rack, three spaces high or 5-1/4". All kits include

mounting hardware and are adjustable front & back.