Anchor CA-130U1 Руководство пользователя - Страница 4
Просмотреть онлайн или скачать pdf Руководство пользователя для Динамики Anchor CA-130U1. Anchor CA-130U1 4 страницы. Powered speaker monitor
Печатать страницуBASIC SYSTEM OPERATION
The CA-130U1 monitor is used to amplify the signal from a
microphone, electronic musical instrument or line-level sources
(cassette, CD, DVD, VCR, etc) .
You'll need a connection cable and an AC outlet.
1. Place the CA-130U1 in desired location
2. Set volume control on front of speaker to minimum
3. Plug the power cord into a grounded 115 volt outlet
(220 volt outlet for export model)
4. Plug a microphone into the MIC input jack, or an audio
source into a LINE IN jack
5. Turn the power switch on the rear panel "ON"
(red LED on front panel should light)
6. Adjust the volume, bass & treble controls to desired levels
IMPORTANT: To avoid feedback, do not position
a microphone in front of speaker.
PROBLEMS? Consult the troubleshooting section
on the back page of this manual.
CAUTION: ALWAYS use shielded audio cables on
input connections to prevent interference.
NOTE: For UHF Wireless microphones
& transmitters see page 6.
MIC-90P - Handheld Microphone
Anchor's dynamic, balanced, low impedance micro-
phone with a unidirectional pick-up pattern. It has a
on/off switch and comes with a 20' cable and mic clip.
SS-250 - Speaker Stand
Adjustable stand made of black, anodized aluminum.
LINE IN
The line-level RCA input jacks may be used with audio sources such as computers, VCR's, and
cassette tape or compact disc players. The inputs may be used for two separate sources, or
they may be used to sum L+R stereo outputs to a mono signal without the need for adapters.
MIC IN
An unbalanced, low impedance
microphone input is for use with
the MIC-90P or other mics that
have a 1/4" phone plug.
CA-130U1 ACCESSORIES
HC-1550 - Hard Travel Case
Holds up to two CA-130U1's, two mics & accessories.
HC-1610B - Hard Travel Case
Projector Protector - holds projector, CA-130U1 & mic.
CC-100 - Carry Bag
Cordura nylon bag w/ storage compartment.
LINE OUT
The unbalanced Line-out provides a combined signal of all inputs
being used. You can use this function to record your presentation
or to "daisy chain" your CA-130U1 to another powered sound sys-
tem for greater crowd coverage.
Note: This output is post source level; any volume fluctuations for
a specific input will affect the output signal level at this output.
SB-1 - Swivel Stand Mounting Bracket
Mounts the CA-130U1 to a wall, ceiling or speaker
stand. (Speaker stand adapter included.)
SB-3 - Swivel Wall Mounting Bracket
Mounts the CA-130U1 to the wall or ceiling.
SB-360 - Swivel (360
) Wall Mounting Bracket
o
Mounts the CA-130U1 to the wall or ceiling.
POWER SWITCH
ClassACT
CONTROL PANEL
Model Shown: CA-130U1
POWER CORD
RM-1 / RM-12 - Single / Dual Rackmount Kits
Mounts CA-130U1 monitors in a standard equipment
rack, three spaces high or 5-1/4". All kits include
mounting hardware and are adjustable front & back.
5