Anchor F3 Руководство по установке - Страница 11

Просмотреть онлайн или скачать pdf Руководство по установке для Палатка Anchor F3. Anchor F3 16 страниц. Frame tent

STEP 10

Tension fabric to frame

Tension tent to frame as shown at right.

Pass left tension ring with web through right

catenary ring.

Pass right tension ring with web through left

catenary ring.

Overlap both tension rings.

Attach top web/ratchet hook to both rings.

Insert bottom hook into slot on upright.

Ratchet to snug tightness.

Go all around the tent and tension all straps to

only snug tightness using ratchet on strap.

Finish tensioning tent as shown in figure 10b.

NOTE:

Installation Cross Web (on 30' model) may be

removed after fabric is installed and prior to final

tensioning. Reinstall at time of take-down.

Tensioning Order

Start tensioning web straps to full

tension in numbering sequence shown

in Figure 10b.

Corners must be equally tensioned so

that punch slot in fabric is centered

on U-bolt in Weldment. Check that all

tension points look level across end

of tent. Watch for wrinkles in fabric

radiating out from tension points. This

may signal that tension is too tight or

unbalanced. Fabric should be smooth.

After corners are tensioned, proceed

to mid tensioning points.

Check that all tension points look level

across the side. Again, watch for

wrinkles.

Figure 10a

Rafter

Catenary

rings

Tension

rings

Upright

Ratchet

Eave Line

Figure 10b