Anchor Navi-Trac Lite Руководство по установке - Страница 6
Просмотреть онлайн или скачать pdf Руководство по установке для Палатка Anchor Navi-Trac Lite. Anchor Navi-Trac Lite 20 страниц. Frame tent 30' wide system
Печатать страницуNAVI-TRAC LT INSTALLATION SAFETY GUIDELINES
Your own installation techniques will evolve to fit the varied needs of your clients, the experience level of your installation
crews, the nature of other tentage that may be common to the installation site being planned, and the equipment that you
may have previously available or with which you feel most comfortable. Whatever techniques you adapt for your crews,
we encourage you to keep safety utmost in mind.
Please read through this assembly manual completely before beginning your installation. Be sure the proper equipment,
crew and safety precautions are in place. We hope that you enjoy the design features of the AnchorSpan™ each time the
unit is installed.
1. It is recommended that workers wear safety shoes and hard-hats on site.
2. When moving frame sections by hand, use proper lifting techniques to protect the back, and avoid pinching fingers
while making hardware connections.
3. Be sure all workers are cautious and attentive to the falling paths of frame sections being raised or lowered.
4. Be aware to avoid contact of frame sections with any overhead power lines near the site.
5. When anchoring the structure, avoid all underground power lines and gas lines or other utility easements.
6. Keep site clear of debris to avoid tripping, especially while carrying frame parts or bundles of fabric.
7. Do not drag bundles of fabric on concrete, asphalt, or ground as this can cause damage to the fabric from abrasion
through the bag.
8. Do not climb onto the fabric "roof" of the structure. When necessary, work safely from a ladder of appropriate size.
9. When standing frame sections to vertical, or when lowering, use a smooth motion and have other workers "foot" the
base of the section to avoid slippage along the ground.
10. When installing gabled end units, be sure all beams are stabilized either by safety guys or cross-cabling until con-
nected to a section of the unit that is already stabilized in this manner.
11. Pay close attention to the proper use of the Navi-Trac Frame Jack (see Page 10). Use care in position the jack care-
fully to maintain proper balance points in relation to weight, wind, and terrain.
12. Before installing fabric, be sure the frame is safely guyed off against the windload the fabric will transfer to the frame
(in the LT and Gabled LT). In the Clearspan (CS) units, be sure X-cabling is in place.
13. When liner ropes are installed on the frame during installation, leave these ropes partially coiled to avoid tangling in
them during frame assembly and standing.
14. When assembly the LT Gabled End units or the Clearspan (CS) units, be sure to safely stabilize the first standing
beam by using the safety guys supplied and the techniques described in Appendix page X-1b.
15. To meet design loads, x-cabled bays (upright and rafter x-cables) must be added such that there are no more than 6
open bays between x-cabled bays or hip ends.
16. Notice that the Clearspan configuration has a narrower bay spacing and extensive X-cabling, especially in the lower
roof area in order to supply the stability needed to omit external guying. Do not install standard Hip Lt or Gabled LT
units without safely guying them out before fabric installation.
17. The installation method described here requires coordination of tasks between workers. A safe installation is
dependent on that coordination. Please work cooperatively as a team.
18. Inspect Site! Consult your local utility locator service or the National Utility Locating Contractors Association
(NULCA) prior to installation. Prior to actual tent assembly, be sure to look up, down, above & below for obstacles,
pipes, wires, trouble, etc.
6