Anchor Navi-Trac LT/CS Руководство по установке - Страница 13

Просмотреть онлайн или скачать pdf Руководство по установке для Палатка Anchor Navi-Trac LT/CS. Anchor Navi-Trac LT/CS 16 страниц. Pavilion 12' to 24' projection

Печатать страницу

Step 7 - Fabric Tensioning

•

At back of pavilion, snap buckles of back-end straps to corresponding buckles at bottom of mids. Insert bottom hook into

slot at back of upright. Tighten just enough so that hook does not fall out of slot. (Figure 7a)

•

At front of mids, insert tension tubes into pockets under curtain. Between mids, use a tension tube splice to connect

tubes. (Figure 7b) Before insertion, hang tension strap with ratchet and hook over the tension tube splice. At ends, hang

tension strap over end of tension tube as shown in Figure 7c.

•

Insert hook of tension strap into slot in front upright. Crank ratchet until tension strap stays in place but do not tension.

Check mids to be sure they are all pulled to the same point in front and back. Check back end straps to be sure they are

tightened uniformly. When you have checked these things, you may now ratchet the front tension straps. Tighten until all

mids are uniformly snug.

Rear Corner Up-

right

Frame attaching

bracket

Use single back

end strap at corner

upright.

Connect male buck-

le to female buckle

at bottom of mid.

Slot in upright

Mid Fabric

Back View

Tensioning Tube Splice

is used between mids

ﬁ ts into ends of tension

tubes.

Figure 7b

Slot in upright

Tension Pocket with

tension tube inserted.

Tension strap over end

of tension tube at front

corner.

Inside view looking at tension

pocket under curtain.

Rear Upright

Frame attaching

bracket

Mid Fabric

Use double back

end strap at

uprights between

mids.

Figure 7a

Figure 7c