Anchor Navi-Trac LT/CS Руководство по установке - Страница 8

Просмотреть онлайн или скачать pdf Руководство по установке для Палатка Anchor Navi-Trac LT/CS. Anchor Navi-Trac LT/CS 16 страниц. Pavilion 12' to 24' projection

Печатать страницу

Step 3 - Raising the Beam Arches

•

Raise ﬁ rst beam. Tie off securely or hold up using adequate installation personnel. Note: There are no stakes or guys

included with this frame, however, the installation kit (sold separately) includes eye bolt and eye nut for attaching to frame

along with safety webs that may be used to stake or tie-off frame to stabilize the ﬁ rst beam while frame is being assem-

bled. See Figure 3a.

•

Raise the second beam arch, keeping base plate in place by using installation personnel or stakes (not included).

Note: Before Raising Beam Arches, all eye nuts and "X" Cables must be in place as

shown in Figure 3a. Turnbuckles should be open all the way.

22' Projection Frame Shown

Frame sizes under 16'

projection have only (2)

cables per bay and no

purlins.

First beam arch as-

sembled and raised.

1/2" x 3 1/4" cap screw

and eye nut may be used

with safety web guys from

installation kit for stabilizing

ﬁ rst raised beam. (instal-

lation kit is an optional

purchase)

Note: If you are installing a 2-bay pavilion, both

bays must be "X" cabled, therefore, eye nuts and

eye bolts must be used at center beam arch (similar

to conﬁ guration at right).

Eyenuts face

ground on sec-

ond rafter.

Note: Turnbuckles

at free end.

Eyenuts on

inside of Rafter

Eyenuts on

inside of Rafter

Eyebolt and safety

webs from installation

kit may be temporarily

installed for stabiliz-

ing ﬁ rst raised beam.

(Use eyebolt with

eyenut from standard

frame hardware.)

Eyenut

Figure 3a