Anchor Explorer Pro Руководство пользователя - Страница 8
Просмотреть онлайн или скачать pdf Руководство пользователя для Акустическая система Anchor Explorer Pro. Anchor Explorer Pro 13 страниц. Anchor audio portable sound system
Также для Anchor Explorer Pro: Руководство пользователя (8 страниц), Руководство пользователя (4 страниц), Руководство пользователя (8 страниц)
Печатать страницу
- 1. Troubleshooting Guide
- 2. Important Safeguards
- 3. Specifications
- 4. Getting Started
- 5. Wireless Microphone Operation
- 6. Wireless Operation
- 7. Battery Operation
- 8. Battery Level Indicator
- 9. Charging Batteries
- 10. Replacing Transmitter Battery
- 11. General Operation
- 12. Line Inputs
- 13. Line Outputs
- 14. Speaker Output
Diversity Wireless by Anchor Audio
Anchor Audio UHF wireless is a 16 channel, diversity wireless
NOTE:
system that utilizes two independent antennae to receive signal. The
When using a
dual wireless
diversity feature means that the receiver will process the stronger of
unit, make
the two antenna signals, effectively minimizing dropouts and
sure each
interference from other transmitting sources. The antennae are
microphone is
mounted internally so there are no obstructions or risk of damage.
set to a
different
Receiver Channel Selection
channel
Before you use your UHF wireless system, you
frequency.
will need to select a wireless frequency channel.
NOTE:
If you
experience
Transmitter Channel Selection
ongoing
Handheld Transmitter:
interference
with your
wireless
system, the
selected
frequency
may be
incompatible
with other RF
Body-pack Transmitter:
systems in
your area.
Try a different
channel.
Wireless Microphone Operation
Both the receiver and microphone must be set to the same channel.
NOTE:
Be sure that
the MIC/LINE
switch is in
the "MIC"
position when
a mic is
plugged into
the body-pack
transmitter.
1. Locate the Wireless Channel selector on the back panel.
2. Set the Channel (frequency) of the receiver to 1 thru 16.
1. Unscrew battery cover on lower end of
microphone.
2. Set the Channel Selection to match the
channel setting on the receiver.
3. Replace the battery cover.
1. The channel selection dial is located on
the side of the transmitter.
2. Set Channel to match the channel setting on the receiver.
1. For body-pack transmitter, insert mic plug into the MIC jack.
2. Turn the transmitter power ON, the red LED will flash once.
(If the red LED stays on, the battery is low.)
3. Turn the Explorer PRO power switch to ON. Pull out the
volume knob for the correct microphone channel.
4. The RX indicators will light (one indicator at a time lights)
when the wireless signal is being transmitted and received.
WIRELESS OPERATION
7