Athena BATHROOMS Fleet Vanity Руководство по установке - Страница 3

Просмотреть онлайн или скачать pdf Руководство по установке для Сантехника Athena BATHROOMS Fleet Vanity. Athena BATHROOMS Fleet Vanity 8 страниц.

Installing the Fleet Drawer

Remove the Drawer from the Drawer Body

1. Open the drawer fully. On the underside of the drawer

locate the tabs on each side, press the tabs while lifting

the drawer and pulling towards the front at the same time.

This will release the drawer from it's runners.

Please refer to the end of these instructions for further

information on the drawers.

2. Place the Drawer body into its desired position within the

Fleet Frame. Ensure that the sides of the Drawer frame do

not interfere with any plumbing.

3. Screw the Drawer body in place using

No.8x25mm (or longer) countersunk screws,

placing the screws in the predrilled holes. Further

screws may be added in the other pre-drilled

holes.

4. Using No.8x25mm Counter sunk screws fix the Drawer

body into place at the indicated points.

5. If applicable, fit the optional drawer handle offered by

Athena. The drawer panel is pre-drilled inside with 3

small holes to suit the handle. Only use a hand screw-

driver to secure the handle to the drawer, do not use a

cordless driver as this may strip out the hole.

An alternative design Drawer handle or pull can be

secured to the top edge or Drawer front.

Screw

Press Tab

Screw