Electrolux ESF 63021 Руководство пользователя - Страница 16
Просмотреть онлайн или скачать pdf Руководство пользователя для Посудомоечная машина Electrolux ESF 63021. Electrolux ESF 63021 20 страниц.
Печатать страницу16 electrolux
Do these steps to remove the
appliance worktop:
1. Remove the rear screws (1).
2. Pull the worktop from the behind the
appliance (2).
3. Lift the worktop and move it from the
front slots (3).
WATER CONNECTION
Water inlet hose
Connected the appliance to a hot (max.
60°) or cold water supply.
If the hot water comes from alternative
sources of energy that are more environ-
mentally friendly (e.g. solar or photovoltaic
panels and aeolian), use a hot water supply
to decrease energy consumption.
Connect the inlet hose to a water tap with
an external thread of 3/4".
Caution! Do not use connection hoses
from an old appliance.
The water pressure must be in the limits (re-
fer to the chapter 'Technical data'). Make
sure that the local water authority gives you
the average mains pressure in your area.
Make sure that there are no kinks in the
water inlet hose and that the water inlet
hose is not squashed or entangled.
Turn the inlet hose to the left or the right to
suit the installation. Fit the locknut correctly
to prevent water leaks.
4. Use the adjustable feet to adjust the
level of the appliance.
5. Install the appliance under the kitchen
worktop. Make sure that there are no
kinks in the water hoses and that the
water hoses are not squashed.
If a repair is necessary, the appliance must
be easily accessible for the engineer. Install
the appliance worktop to the appliance if
you want to use the dishwasher as a free-
standing appliance.
The plinth on freestanding appliance is not
adjustable.
Adjusting the level of the appliance
Make sure that the appliance is level to
close and seal the door correctly. If the level
of the appliance is correct, the door does
not catch on the sides of the cabinet. If the
door does not close correctly, loosen or
tighten the adjustable feet until the appli-
ance is level.
Caution! Do not connect the appliance
to new pipes or pipes that are not used
for a long time. Let the water run for
some minutes, then connect the inlet
hose.
Water drain hose
1. Connect the water drain hose to the
sink spigot and attach it under the work
surface. This prevents that the waste
water from the sink goes back into the
appliance.
2. Connect the water drain hose to a
stand pipe with vent-hole (minimum in-
ternal diameter 4 cm).