FormFit HD 13R12 Инструкции по установке - Страница 2

Просмотреть онлайн или скачать pdf Инструкции по установке для Автомобильные аксессуары FormFit HD 13R12. FormFit HD 13R12 4 страницы. Hood protector

Starting with the inner holes:

a) Place a clip over each of the anti-abrasion film pads on the edge of the hood as shown below in Illustration #2

b) Insert a pin through the protector into each of the clips. See Illustration #2

c) Insert the #6 x 5/8 screw through an L - bracket and into the clip. See Illustration #2

d) Make sure all the components are well seated together; the protector is centered on the hood, and then tighten the screws into the clips.

10. Repeat step #9 for the outer holes.

11. On some vehicles it may be necessary to adjust the hood bumpers and/or latch for proper clearance.

Note: Do not pull on the protector when opening or closing the hood.

Illustration #1: Pedestal Location

Illustration #2: Clip Configuration

Step #8

CARE INSTRUCTIONS

Clean the protector with a mild soap and water solution or plastic cleaner only. Do not use chemicals or solvents. Periodically

checks to make sure that the bumpons are in place and that the protector is secure. Avoid using automatic car washes. Do not pull on the

protector when opening or closing the hood.

Patent No. 6,892,427

Step #9a

e Instructions

Thank you for purchasing a FormFit hood protector.

Retain sheet for Care Instructions and Kit Information.

Step 9b.

Steps 9c & 9d.

370mm

Step #9b

Step 9a.

Step #9c & 9d

Rev0.150705