Anden A300V3 Руководство по установке и эксплуатации - Страница 9

Просмотреть онлайн или скачать pdf Руководство по установке и эксплуатации для Осушитель Anden A300V3. Anden A300V3 12 страниц.

OPERATION

1. Check all wiring from the electrical service line to the dehumidifier.

2. Check all wiring between the dehumidifier and the Model A76 Control.

TURN ON & SET MODEL A76 CONTROL

1. When power is supplied to the dehumidifier, the control will display the measured humidity and initially be in OFF Mode.

2. Press the ON button on the Model A76 Control.

3. The default humidity setting is 60%RH. Use the UP/DOWN arrow buttons to adjust the humidity setting. The first button press will display the

current setting and SET on the LCD display. Each subsequent push of the buttons will change the setting by 1%RH.

4. When desired humidity setting has been set, the control will return to Normal Mode, displaying the measured humidity 5 seconds after the last

button press/release.

SEQUENCE OF OPERATION

When the measured humidity is greater than the setting, the control will activate the dehumidifier output, the dehumidifier will begin dehumidifying,

and ON will blink on the Model A76 LCD display. When the measured humidity falls 3% below the setting, the control will deactivate the dehumidifier

output, the dehumidifier will stop dehumidifying and the LCD will display a solid ON.

CONTROL LIMITS

If the control measures a dew point below 40°F OR a temperature above 99°F, the control will deactivate the dehumidifier output, if actively

dehumidifying, the dehumidifier will stop dehumidifying and ON and

the measured dew point is greater than 45°F or the measured temperature is below 94°F, depending on what control limit was exceeded.

Reference the Model A76 Installation Instructions for additional information.

ALTERNATE CONTROLS

If using an alternate control, reference the Installation and Operating Instructions supplied with the control.

FILTER

After initial installation, the air filter should be replaced every 6 months. Remove the filter access panel to remove and replace the filter.

DRAIN

The drain should be checked periodically to ensure there are no blockages or air lock in the drain system.

CONTROL

The surface of the Model A76 Control can be cleaned with a damp cloth or non-abrasive general cleaner. Do not spray any liquid directly on the

control. Spray water or cleaner onto a soft cloth and gently wipe the surface of the control.

will blink on the LCD screen. The control will resume normal operation when