Electrolux ZUCI Руководство - Страница 15

Просмотреть онлайн или скачать pdf Руководство для Посудомоечная машина Electrolux ZUCI. Electrolux ZUCI 16 страниц. Undercounter dishwasher
Также для Electrolux ZUCI: Руководство по установке, эксплуатации и техническому обслуживанию (20 страниц)

DISHWASHER DOES NOT WASH

WELL

GLASSES AND DISHES ARE

NOT DRIED PROPERLY

CONDENSATION ON GLASSES

STAINS ON THE GLASSES

EXCESSIVE FOAM IN THE TANK

SMEARS OR SPOTS ON THE

GLASSES

THE WASH OR RINSE ARMS

TURN SLOWLY

TROUBLESHOOTING

1. Check if the suction filter is dirty and clean it thoroughly.

2. Check if the wash jets are clogged by solid food remains.

3. Check that the initial amount of detergent or subsequent additions are

correct.

4. The selected wash cycle is too short. Repeat the cycle.

5. Check that the tank temperature is between 55°C and 65°C.

6. Check that the dishes are stacked correctly in the racks.

1. Check the instructions for the amount of rinse-aid (see "setting the

dispensers" paragraph).

2. Check that there is rinse-aid in the container and if necessary top up.

3. Check the set amount of rinse-aid (see "setting the dispensers" para-

graph).

4. Check that the water temperature is between 80°C and 90°C.

1. Check that there is rinse-aid in the container and if necessary top up.

2. Check the set amount of rinse-aid (see "setting the dispensers" para-

graph).

3. Remove the rack of glasses immediately the cycle has ended.

1. Only use "non-foaming" products for professional dishwashers.

1. Check that the wash water temperature is not less than 50°C.

2. Check if the amount of product dispensed by the detergent dispenser is

excessive (see "setting the dispensers" paragraph).

3. Ensure that the tank has not been cleaned with unsuitable cleaners.

Drain the tank and rinse thoroughly before new wash cycles.

4. If a foaming detergent has been used, drain and refill the tank with

water until the foam disappears.

1. Reduce the amount of rinse-aid (see "setting the dispensers" para-

graph).

1. Remove and thoroughly clean the arms.

2. Clean the wash pump suction filter.