Communications Specialties TwinSplit E.D. Руководство пользователя - Страница 2

Просмотреть онлайн или скачать pdf Руководство пользователя для Адаптер Communications Specialties TwinSplit E.D.. Communications Specialties TwinSplit E.D. 4 страницы. For vga

Печатать страницу

Installation

1. Locate TwinSplit E.D. within 6 feet of the computer.

2. Connect the 6 ft. VGA jumper cable supplied from the VGA output of the

computer to the connector marked VGA.

3. Connect the VGA compatible monitors to the OUTPUT on the rear of

TwinSplit E.D. Monitor extension cables (CAB-27) may be used to extend

the distance up to 700 feet, according to the table below.

4. Plug the 9 Vdc wall power transformer supplied into the jack on the rear of

TwinSplit E.D.

5. Plug the power transformer into an AC power wall outlet. The front panel

LED should glow red, indicating the unit is properly powered.

6. Turn on the computer and the monitor(s). The monitor(s) will now display

the computer's output.

7. The front panel knobs are used to

adjust the gain and peaking of the

amplifiers of the TwinSplit E.D. to

compensate for the long extension

cable being used. These knobs have

6 positions from SHORT to LONG

and correspond to cable lengths for

standard VGA up to 480 lines

approximately as shown.

Note: For SUPER-VGA modes operating at 600 lines, the maximum

recommended length is 600 feet. For SUPER-VGA modes operating at 768

lines, the maximum recommended length is 500 feet.

8. As shipped, TwinSplit E.D. is internally jumpered to support a standard color

VGA monitor. The

internal jumpers are

located on the jumper

block JP1 and may be

changed for different

monitor types as

shown.

Knob Position

Monitor Type

Color VGA

Monochrome VGA

8514/A VGA

XGA

JP1 Jumpers

2 and 5

3 and 5

1 and 3

1 and 4

Cable Length

0-125 ft.

125-250 ft.

250-375 ft.

375-500 ft.

500-600 ft.

600-700 ft.

JP1