Electrolux EC4200AOW1 Руководство пользователя - Страница 12
Просмотреть онлайн или скачать pdf Руководство пользователя для Морозильная камера Electrolux EC4200AOW1. Electrolux EC4200AOW1 48 страниц.
Также для Electrolux EC4200AOW1: Руководство пользователя (10 страниц)
Печатать страницу
12
www.electrolux.com
Problem
There is too much frost
and ice.
The temperature in the ap‐
pliance is too low/too high.
8.2 Customer Service
If your appliance is still not working
properly after making the above checks,
contact the nearest Authorised Service
Centre.
To obtain fast service, it is essential that
when you apply for it you specify the
model and serial number of your
appliance which can be found either on
the guarantee certificate or on the rating
plate located on the external right side of
the appliance.
Possible cause
Food placed in the appli‐
ance was too warm.
The lid is not closed prop‐
erly.
The lid is not closed cor‐
rectly or the gasket is de‐
formed/dirty.
The water drainage plug is
not correctly positioned.
Temperature is set incor‐
rectly.
The temperature regulator
is not set correctly.
The lid is not closed cor‐
rectly.
The products' temperature
is too high.
Many products are stored
at the same time.
The thickness of the frost
is greater than 4-5 mm.
The lid has been opened
often.
Products to be frozen are
placed too closely to each
other.
8.3 Replacing the lamp
Solution
Allow food to cool to room
temperature before storing.
Check if the lid closes well
and the gaskets are un‐
damaged and clean.
Refer to "Opening and
closing the lid".
Position the water drain‐
age plug in the correct
way.
Refer to "Operation" chap‐
ter.
Set a higher/lower temper‐
ature.
Refer to "Opening and
closing the lid".
Let the product tempera‐
ture decrease to room tem‐
perature before storage.
Store less products at the
same time.
Defrost the appliance.
Open the lid only if neces‐
sary.
Make sure that there is
cold air circulation in the
appliance.
The appliance is equipped
with a longlife LED interior
light.
It is strongly recommended
to use original spare parts
only.
Use LED bulbs (E14 base)
only. The maximum power is
shown on the lamp unit.