Andersen 618803 Руководство по установке рукоятки - Страница 3
Просмотреть онлайн или скачать pdf Руководство по установке рукоятки для Система открывания дверей Andersen 618803. Andersen 618803 5 страниц.
Печатать страницу
7/8" Machine Pan Painted
1" SMS Pan
STEP 1: INSTALL HANDLE SET
1" SMS Pan Painted
LEFT
1" Machine Pan Painted
HANDED
1-1/2" Machine Flathead
A
Exterior
#10
1-1/2" Machine Flathead
2" SMS Pan Painted
Interior
#12
Slider
5/8" SMS Pan Painted
NOTE: Trim plates should not be installed
on door while completing below
1.
Insert handle with spindle into exterior
trim plate (with Andersen logo) in
downward position and rotate slightly to
secure it.
2.
Repeat for other handle and interior trim
plate.
STOP: Laminated Fixed Glass Doors only.
Slider must be replaced. See Interior Trim
Plate Kit for further instructinon.
Interior
C2
1.
Rotate the handles into a vertical position.
2.
Install exterior and interior trim plates
together using two 1 1/2" pan head
screws onto the door. Spindle will pass
through the square hole in the lock case
and into the other handle.
3.
Rotate handle to a horizontal position.
1" SMS Pan
1" SMS Pan Painted
1" SMS Pan Painted
1" Machine Pan Painted
1" Machine Pan Painted
TOOLS NEEDED
1-1/2" Machine Flathead
1-1/2" Machine Flathead
#10
#10
1-1/2" Machine Flathead
B
Exterior
1-1/2" Machine Flathead
2" SMS Pan Painted
2" SMS Pan Painted
#12
#12
5/8" SMS Pan Painted
5/8" SMS Pan Painted
1.
Check orientation of the lock case by
looking into the handle holes.
steps.
2.
If notch is facing away from the glass
panel as seen above, proceed to Step C1.
3.
If the notch is pointed downwards,
proceed to Step C2.
D
Interior
Slider
Dead
bolt key
cylinder
with thumb
latch
1.
Install lock case trim plate onto the edge
of the door and fasten with one 5/8"
screw. Do not overtighten.
2.
Insert dead bolt key cylinder into lock
case. Turn thumb latch to engage
deadbolt fully and fasten with one 1 1/2"
flathead screw. Do not overtighten.
NOTE: Slider feature will function only on
doors featuring Quick Change System.
5/8"
1 1/2"
1 1/2"
C1
1.
2.
3.
1
2
3
Flathead screw
x 2 Pan head screws
Interior
2
2
Rotate the handles into a horizontal
position.
Install exterior and interior trim plates
together using two 1 1/2" pan head
screws onto the door. Spindle will pass
through the square hole in the lock case
and into the other handle.
Proceed to step D.