Bosch Instructions for Use Руководство по эксплуатации - Страница 2

Печатать страницу

Bosch Instructions for Use Руководство по эксплуатации

Installation

Care and cleaning

Heat exchanger

– Scope of delivery: dryer, installation and operating instructions.

– Check dryer for transport damage.

The dryer's heat exchanger is cleaned automatically during drying.

– The dryer is very heavy. Do not attempt to lift it on your own.

Do not pull out the condensation container during the cleaning process.

– Be careful to avoid sharp edges.

– Do not set up in a room that is susceptible to frost. Freezing water may cause damage.

Dryer housing, control panel, air intake

– If in doubt, have the appliance connected by a specialist.

Wipe with a soft, damp cloth.

– Do not lift the dryer by protruding parts (e.g. the door) - risk of breakage.

Do not use harsh cleaning agents or solvents.

Setting up the dryer

Take all accessory parts out of the

Remove detergent and cleaning agent residue immediately.

– The appliance plug must always be accessible.

drum. The drum must be empty.

– Ensure that the appliance is installed on a clean, level

Filter in the condensation container

and firm surface.

The filter is cleaned automatically when the condensation container is emptied.

– Do not obstruct the air inlet on the front of the dryer.

However, the filter should still be cleaned regularly under running water

– Keep the area around the dryer clean.

stubborn deposits/dirt from building up.

– Make the dryer level using the threaded feet

and a spirit level.

– Do not remove the threaded feet under any

circumstances.

1. Pull out the condensation container.

Do not set up the dryer behind a door or sliding door, as this may obstruct

the dryer door or prevent it from opening. This will prevent a potentially

fatal danger to children from locking themselves in.

Mains connection

see Safety instructions

page 13.

2. Pull the filter out of its snap-in lock.

– Connect to an AC earthed socket. If in doubt have the

socket checked by a specialist.

– The mains voltage and the voltage shown on the rating

page 10) must be the same.

Clean and level

plate (

– The connected load and necessary fuse protection are

Make sure that the air inlet

specified on the rating plate.

remains unobstructed

Frost protection / Transport

Do not operate the dryer if

3. Clean the filter under running water or in the dishwasher.

there is a danger of frost.

Frost protection - preparation

1. Empty the condensation container

page 4.

2. Select any programme using the programme selector.

3. Press the

Start/Stop button

condensed water is pumped into

the container

4. Wait 5 minutes and then empty the condensation container again.

4. Refit the filter.

5. Turn the programme selector to Off.

Transport

– Prepare the dryer

see Frost protection - preparation.

5. Insert the condensation container so that it locks into place.

– Transport the dryer in a vertical upright position.

– Following transportation, do not use the dryer for two hours.

The dryer contains residual water;

Only operate the dryer with the filter inserted.

this can flow out if the dryer is tilted.

Moisture sensor

Signal

The dryer is equipped with stainless steel moisture sensors. Moisture sensors measure how

damp the laundry is. A thin layer of limescale may build up on the moisture sensors after

Switching on/off an acoustic signal at the end of the programme

prolonged use.

1. Open the door.

2. Clean the moisture sensors using a damp sponge with a rough surface.

Do not use steel wool or abrasive materials.

Turn to

1 x to the

Press and hold Low heat

Press Low heat

Turn to

Off

right

and turn 3 x to the right

switch on/off the signal

Off

Low Heat

light on

an acoustic signal at the end of the programme is switched on.

Low Heat

light off

an acoustic signal at the end of the programme is switched off.

Appliance must be switched off.

Technical data

Dimensions (DxWxH)

60 x 60 x 85 cm (height adjustable)

Weight

approximately 51 kg

Max. capacity

7 kg

Condensation container

4.0 l

Connection voltage

220-240 V

Connected load

max. 1000 W

Fuse protection

10 A

Ambient temperature

5 - 35°C

Product number

This prevents

under the door

Production number

The rating plate can be found on the back of the dryer.

Drum interior light

(depending on model)

(bulb E14, 25 W)

The drum lights up after the door is opened or closed, and after the programme starts,

and switches off automatically. Changing the bulb

page 12.

Consumption rates

Residual moisture in the fabrics

Energy

Fabrics/programmes

Drying time**

after spinning

consumption**

Cottons 7 kg

Cupboard Dry*

1400 rpm

(50%)

134 min

1.75 kWh

1000 rpm

(60%)

155 min

2.03 kWh

800 rpm

(70%)

175 min

2.32 kWh

Iron Dry*

1400 rpm

(50%)

98 min

1.24 kWh

1000 rpm

(60%)

119 min

1.52 kWh

800 rpm

(70%)

139 min

1.81 kWh

Easy-Care 3.5 kg

Cupboard Dry*

800 rpm

(40%)

54 min

0.57 kWh

600 rpm

(50%)

68 min

0.72 kWh

* Programme setting for testing in accordance with applicable standard EN61121.

** The values may differ from those specified, depending on the type of fabric, composition of

laundry to be dried, residual moisture in the fabric and the amount of laundry being loaded.

Fabrics/programmes

Drying time

Annual energy consumption

Cottons 7 kg / 3.5 kg*

Cupboard Dry***

124 min / per cycle

258 kWh / per year

***Programme setting for testing and energy labelling in accordance with Directive 2010/30/EU.

Optional accessories

(from after-sales service using order number)

Washer-dryer stack connection set

WTZ

The dryer can be placed on top of a suitable washing machine with the same width and depth

11310

to save space. The dryer must be fastened to the washing machine using this connection set.

WTZ 11300: with pull-out worktop.

Installation underneath the worktop

WTZ

Instead of the appliance covering plate, you must have a metal cover fitted by a specialist.

10290

WMZ

Platform

20500

For easier loading and unloading. The basket contained in the drawer can be used

to carry the laundry.

Normal noises

What to do if...

If you cannot rectify a fault yourself (e.g. switching off/on) , please contact our after-sales

During drying, the compressor and the pump generate some noise which is entirely normal.

service. We will always find an appropriate solution and will avoid unnecessary visits by

engineers. Trust the expertise of the manufacturer and rest assured that the repair will be

carried out by trained service technicians using original spare parts. The contact details of your

local after-sales service can be found in the enclosed after-sales service directory, or by calling

one of these numbers:

The compressor in the dryer may

– GB 0844 892 8979 (Calls from a BT landline will be charged at up to 3 pence per minute.

A call set-up fee of up to 6 pence may apply.)

occasionally generate a humming noise.

The volume and pitch of this may vary

– IE 01450 2655

depending on the selected

When contacting the after-sales service, please quote the appliance's product number (E no.)

programmes and the progress of the

and production number (FD) (see under the loading door).

drying.

Turn the programme selector to Off and unplug the mains plug from the socket.

The

Start/Stop indicator lamp

does not light up.

The display panel light and

indicator lights (depending on

model) go out and the

Start/Stop indicator light

flashes.

The Container indicator lamp

The compressor in the dryer is ventilated

and the

Start/Stop button are

from time to time, which creates a whirring

flashing.

sound.

The Clean indicator lamp and

Start/Stop button are flashing.

Dryer does not start.

Water is leaking out.

The door opens by itself.

Creasing.

The automatic cleaning process causes

Drying result is not satisfactory

a clicking noise.

(laundry feels too damp).

Drying time too long.

The process of pumping the condensation

into the condensation container generates

The humidity in the room

pumping noises.

increases significantly.

Power failure.

Other intermittent noises and

vibrations.

Loud humming noise for several

seconds.

Safety instructions

Emergency

– Pull the appliance plug out of the socket immediately or disconnect the fuse.

ONLY use the

– in rooms inside the house.

dryer...

– to dry fabrics.

The dryer must

– be used for purposes other than those described above.

NEVER...

– be modified in terms of its technology or properties.

Hazards

– The dryer must not be used by children or persons who have not been

instructed in its use.

– Do not leave children unsupervised near the dryer.

– Keep pets away from the dryer.

– Remove all objects from pockets, and lighters in particular

explosion.

– Do not lean or sit on the door

Risk of tipping.

Mains plug plugged in?

Installation

– Secure loose cables

Risk of tripping.

Programme selected?

– Do not operate a dryer if there is a risk of frost.

Check the socket fuse.

Energy-saving mode is activated

see the separate

Mains

– Connect the dryer to an AC earthed socket according to specifications,

Energy-saving mode instructions.

connection

otherwise it cannot be guaranteed that the appliance is completely safe.

– The cable cross-section must be sufficient.

– Only use earth-leakage circuit breakers with the following symbol:

– The appliance plug and socket must be compatible.

– Do not use multiple plugs/connectors and/or extension cables.

Empty the condensation container

page 4.

Clean the condensation container filter if necessary

– Do not touch or hold the appliance plug with wet hands

page 9.

Risk of electric shock.

Dryer transported?

Wait 2 hours and start again.

– Never pull the appliance plug out of the socket by its cable.

– Do not damage the mains lead

Risk of electric shock.

Rinse the fluff filter under running water

page 4.

Operation

– Only load the drum with laundry.

Start/Stop button selected? Door closed?

Check the contents before you switch the dryer on.

Programme set? Ambient temperature greater than 5 °C?

– Do not use the dryer if the laundry has been in contact with solvents, oil, wax,

Make sure the dryer is level.

grease or paint (e.g. hair styling products, nail varnish remover, stain

remover, cleaning solvent, etc.)

Risk of fire/explosion.

Push the door closed until you hear it click into place.

– Dust (e.g. coal dust, flour) poses a danger: Do not use the dryer

Risk of explosion

Laundry load exceeded?

– Do not put laundry containing foamed material/rubber in the dryer

Remove articles of clothing immediately after the end of the

material may be destroyed and the dryer be damaged due to possible

programme, hang up and pull into shape.

deformation of the foamed material.

Unsuitable programme selected

page 7.

– When cleaning the fluff filter, make sure that no foreign material (down or

Warm laundry feels damper than it actually is.

filling material) gets into the air duct opening. If necessary, clean the drum

The selected programme does not suit the load.

beforehand with a vacuum cleaner. If foreign material should still get into the

Use another drying programme or, in addition, select the

air duct

call the after-sales service

Risk of fire/explosion.

time programme

page 7.

– Switch off the dryer once the programme has ended.

Use fine adjustment for the drying result

page1/2 and 6.

– The water from condensation is not drinking water and may be contaminated

with fluff.

Fine layer of limescale on the humidity sensors

Clean the humidity sensors

page 9.

Defect

– Do not use the dryer if it is defective or if you suspect that it is.

Programme termination, e.g. tank full, mains power supply

Repairs must only be carried out by the after-sales service.

failure, door open or maximum drying time reached.

– Do not use the dryer if the mains cable is defective. To avoid danger, only

Rinse the fluff filters under running water

page 4.

have the defective mains cable replaced by the after-sales service.

Insufficient supply of air

ensure that air can circulate.

– Always pull the mains plug out of the socket before changing the bulb for

Air inlet possibly blocked

Clear inlet

page 8.

the interior light

Risk of electric shock.

Ambient temperature higher than 35 °C

ventilate the

Spare parts

– Only use genuine spare parts and accessories for safety reasons.

room.

Make sure the room is sufficiently ventilated.

Disposal

– Pull out the appliance plug, then cut off the mains cable from the appliance.

Dispose of at a municipal waste disposal facility.

– Heat exchangers contain a fluorinated greenhouse gas covered by the

Remove laundry from the dryer immediately and spread out.

Kyoto protocol (R134a)

dispose of in a proper manner.

This allows the heat to dissipate.

Capacity: 0.22 kg.

Not an error.

– Packaging: Keep all packaging out of reach of babies and children

Normal noises

page 11.

Risk of suffocation.

Has the condensation container been properly inserted?

– All materials are environmentally sound and can be reused.

Push the condensation container all the way in.

Dispose of in an environmentally-responsible manner.

Not an error. Normal noises

page 11.

Risk of

elastic

Dryer

en Instruction manual