Andersen Windows & Doors 901724 Руководство по установке - Страница 4
Просмотреть онлайн или скачать pdf Руководство по установке для Оборудование для борьбы с насекомыми Andersen Windows & Doors 901724. Andersen Windows & Doors 901724 14 страниц. 1-1/2” self-storing storm doors with balanced retractable insect screen and integrated close system
Печатать страницуHANG HINGED
STORM DOOR
3
AND REMOVE
SPACER CLIPS
(Left Hand)
a
LEFT HAND HINGED INSTALLS ONLY
FOR RIGHT HAND HINGED INSTALL, SEE PG. 9
1.
Set bottom of door centered in opening. Make sure
orange bottom spacer (J) is sitting on door sill.
2.
Tip top of door into opening while ensuring bottom
of door frame rests on orange spacer. TIP: Place foot
against door bottom while tipping top of door frame
assembly into opening.
3.
Door frame assembly is properly seated in opening
when both latch rail and hinge rail are flush against
mounting surface, while hinge rail and bottom spacer
are resting on door sill. NOTE: The gap between top of
door and rain cap is intentionally uneven at this step.
d
1.
Using 1/8" drill bit, drill holes in door jamb
through holes in hinge rail.
2.
Fasten hinge rail to door jamb using eight
1" screws. Do not overtighten screws.
For a Right Hand Installation, go to Page 9.
I
H
Handle Clip
Spacer Clips
X
b
VIEW
J
1.
While holding door in position, use 1/8" drill
bit from the installation kit to drill a hole in the
mounting surface through two pre-drilled holes
(indicated above with extra-large green arrows).
2.
Fasten door to mounting surface using two 1"
screws.
3.
Pre-drill holes in mounting surface through
remaining twelve holes in side rails, then
fasten door to mounting surface using
twelve 1" screws.
i
e
VIEW
1.
If your door has clear protective film, start
at the frame corners and remove the clear
protective film from both the interior and
exterior of door frame.
1/2" Self-Drill Pan Painted
5/8"
1/2"
3/4" Machine Flathead
J
1 1/2"
7/8" Machine Pan Painted
1 1/2"
1" SMS Pan
Bottom Spacer
X
1" SMS Pan Painted
VIEW
1" Machine Pan Painted
1-1/2" Machine Flathead
5/8"
#10
1-1/2" Machine Flathead
5/8"
2" SMS Pan Painted
#12
5/8" SMS Pan Painted
i
f
VIEW
1.
TIP: If notch is not facing away from glass panel,
use handle and spindle to rotate spindle hole
into correct orientation.
4
1/2"
Tools needed:
1"
2"
1/8"
1"
!
c
CAUTION
Do not open door by pulling on the
handle holes. Injury could result
1.
Unlatch upper and lower
handle side spacer clips by
pulling tab toward you.
1 1/2"
2.
Remove two handle hole
fasteners by inserting Phillips
screwdriver into handle hole
and firmly pressing them
out. Properly discard orange
handle fasteners.
1 1/2"
3.
Grasp edge of door and firmly
pull door open.
LOCK CASE
Look into handle holes on door to make
sure lock case is oriented properly. Notch in
square spindle hole should be facing away
from glass panel.
x 22
!
X
VIEW
1/2"
2"
GLASS