Troubleshooting
,
WARNING!
RISK OF ELECTRICAL SHOCK !
EXPLOSION HAZARD!
Repairs or replacement of parts
may be carried out by authorized
technicians only.
Problem
Dryer does not start.
Start/Stop indicator light does not
Start/Stop indicator light does not
illuminate.
Program has been interrupted.
Filter indicator light flashes.
Filter indicator light flashes.
Filter indicator light illuminates.
Start/Stop indicator light does not
Start/Stop indicator light does not
illuminate. Wrinkle block/End indicator
lights.
lights.
Degree of drying has not been reached
or the drying time is too long.
or the drying time is too long.
Before calling customer service,
check whether you can rectify the
fault yourself by means of the
following table.
If a fault cannot be rectified or
a repair is required:
Possible cause
Power cord not plugged in at all or not inserted
correctly.
Fuse blown or circuit breaker tripped.
Start/Stop button not pressed.
Door not closed.
Ambient temperature below 41 °F/5 °C.
Lint filter dirty.
Fault in program sequence or malfunction.
The room/cabinet is not adequately ventilated.
Condensation outlet.
Fault in program sequence or malfunction.
Fault in program sequence or malfunction.
Moisture sensor dirty.
Laundry was too wet.
Unsuitable program selected.
Maximum drying time was exceeded.
Motor limit temperature was exceeded.
1. Set program selector to Off".
2. Turn off the circuit breaker.
3. Pull the mains plug out of the
socket.
4. Call customer service
(see page 20).
Remedial action
Insert main plug correctly.
Replace blown fuse or reset circuit breaker.
Press Start/Stop button.
Close door.
Increase room temperature.
Clean filter as described on page 17.
Switch off/switch on again.
Switch off dryer, leave to cool down for 30 min,
switch on again. Restart program.
Provide an adequate supply of fresh air.
Switch off/switch on again.
Check hose for condensation outlet.
Switch off dryer, leave to cool down for 30 min,
Switch off dryer, leave to cool down for 30 min,
switch on again. Restart program.
Clean moisture sensor as described on page 18.
Switch off/switch on again.
Spin laundry at higher speed in the washing
machine. Switch off/switch on again.
Select program with aid of the program selection
table (see page 23). Switch off/switch on again.
Clean lint filter (see page 17).
Check hose for condensation outlet.
Spin laundry at a higher speed in your washer.
Switch off dryer, leave to cool down for 30 min.
Switch on again. Start program.
19
Печатать страницу