Anderson M-115 Руководство пользователя - Страница 18

Просмотреть онлайн или скачать pdf Руководство пользователя для Коммунальный автомобиль Anderson M-115. Anderson M-115 18 страниц. Log loader on a r-flex 410 trailer

Печатать страницу

Maintenance and Troubleshooting



 Problems

4.6

4.6.1 – The motor of

the hydraulic unit does

not work.

4.6.2 – The loader does

not move or it has NO

power

4.6.3 – No power with

only one control

Visit our Internet site :

Visit our Internet site

 Possible causes

1 –The gas tank is empty.

2 – The gas line valve is closed.

3 – The low oil level sensor has been

activated.

4 – The spark plug is dirty or defective.

5 – The motor has been flooded because the

retrun gas valve has not been shut off the

day before or during transportation.

1 – The connections are not connected

properly.

2 – The hydraulic oil level of the unit is too

low. Missing oil or a leak.

3 – Missing oil pressure. The pump of the

unit (or tractor) is worn out.

4 – Missing oil pressure. The safety valve

which controls the pressure is defective.

5 – Missing oil pressure

1 – Oil leak from cylinder

2 – The distributor safety valve is defective.



www.anderson-machineries.com



1 – Add gas to the tank and restart.

2 – Open the return gas valve and restart.

3 – Add motor oil and restart.

4 – Clean the spark plug or change it, and restart.

5 – Take off the spark plug, dry it and dry out the

cylinder by activating the starter crank. Replace the

spark plug, fill with motor oil and restart.

1 – Check all connections and their compatibility.

2.1 – STOP IMMEDIATELY THE UNIT and check for

oil leaks and breakage. Tighten, repair, or replace if

needed. Add hydraulic oil #32 to the reservoir.

2.2 – Check and clean the sieve (as needed) at the

hydraulic pump intake.

3 – Have a specialist check the pressure. Replace or

repair the pump.

4 – Have someone check your safety valve for

pressure. Clean or replace it if needed.

5 – Wait for the oil to cool. Check oil level and add

if necessary.

1 – Visually check the cylinder joints for leak.

Repair if necessary.

2 – Have a specialist check the pressure. Replace or

repair the safety valve.

www.anderson-machineries.com

(continues).

 Solutions