Bosch WTY877W0AU Руководство по установке и эксплуатации - Страница 38
Просмотреть онлайн или скачать pdf Руководство по установке и эксплуатации для Сушилка Bosch WTY877W0AU. Bosch WTY877W0AU 44 страницы.
Печатать страницу
Faults and what to do about them
en
Faults
Laundry is not dried cor-
rectly or is still too damp.
Drying time too long?
Display panel goes off
and Start button flashes.
Residual water in the
condensate container
despite the dryer being
connected to the con-
densation drain*.
Humidity in the room
increases.
Power cut.
Unusual noises when
drying.
The dryer feels cold
despite drying.
* Depending on the model
If you cannot rectify the fault yourself by turning the dryer off and on, please
Note:
contact our after-sales service.
38
Cause/remedy
After the end of the programme, warm laundry feels damper than it actually
■
is. Spread the laundry out and allow the heat to disperse.
Finely adjust the dryness level – this extends the drying time but does not
■
increase the temperature. Your laundry will become drier ~ Page 28.
Select a programme with a longer drying time or increase the drying level.
■
This does not increase the temperature.
Select a timed programme for subsequent drying of laundry that is still
■
damp ~ Page 26.
If you have exceeded the maximum load for the programme, the laundry
■
may not be dried properly.
Clean the moisture sensor in the drum. The sensor may become covered by
■
a fine layer of limescale or residues of detergents and care products which
then impair its function. Your laundry is not being dried correctly
~ Page 36.
Drying has been interrupted as a result of a power cut, because the conden-
■
sate container is full or because the maximum drying time has been
exceeded.
See also the laundry tips ~ Page 25.
Note:
The fluff filter may be dirty and cause a longer drying time. Clean the fluff fil-
■
ter.
If the air inlet on the dryer is blocked or not freely accessible, this may
■
increase the drying time. Make sure that the air inlet remains unobstructed.
The optimum ambient temperature for drying is between 15 °C and 30 °C.
■
Outside of this range, the drying time may increase.
Insufficient air circulation in the room may increase the drying time. Venti-
■
late the room.
Not a fault. Energy saving mode is active ~ Page 12.
Not a fault. If the condensation drain is installed, residual water remains in
the condensate container due to the dryer's self-cleaning function.
Not a fault. Make sure the room is sufficiently ventilated.
The drying programme is interrupted. Remove the laundry and spread it out,
or restart the programme.
Not a fault. Noises are produced by the automatic cleaning of the heat
exchanger ~ Page 34.
Not a fault. The dryer can dry efficiently at low temperatures using a heat pump.