Electrolux EGC3313 Руководство пользователя - Страница 12
Просмотреть онлайн или скачать pdf Руководство пользователя для Варочная панель Electrolux EGC3313. Electrolux EGC3313 16 страниц. Electrolux hob
Также для Electrolux EGC3313: Руководство пользователя (16 страниц), Руководство пользователя (16 страниц), Руководство пользователя (20 страниц), Руководство пользователя (20 страниц)
Печатать страницу
12 www.electrolux.com
INSTALLATION
WARNING!
Refer to "Safety information" chap-
ter.
WARNING!
The following instructions about in-
stallation, maintenance and ventila-
tion must be carried out by quali-
fied personnel in compliance with
the regulation in force (UNI-CIG
7129 - 7131). Make sure that the
kitchen is well ventilated: keep nat-
ural ventilation holes open (at least
100 cm²) or install a mechanical ex-
tractor hood.
GAS CONNECTION
Choose fixed connections or use a flexible
pipe in stainless steel in compliance with
the regulation in force. If you use flexible
metallic pipes, be careful they do not come
in touch with mobile parts or they are not
squeezed. Also be careful when the hob is
put together with an oven.
Make sure that the gas supply
pressure of the appliance obeys
the recommended values. The ad-
justable connection is fixed to the
comprehensive ramp with a threa-
ded nut G 1/2". Screw the parts
and tighten everything with teflon
tape, if necessary, to get the right
direction.
A)
B)
C)
Rigid connection:
Carry out connection by using metal rigid
pipes (copper with mechanical end) (UNI-
CIG 7129).
End of shaft with nut
Washer
Elbow (if needed)
Flexible connection:
Use a flexible pipe in stainless steel (UNI-
CIG 9891) with a maximum length 2 m.
INJECTORS REPLACEMENT
1.
Remove the pan supports.
2.
Remove the caps and crowns of the
burner.
3.
With a socket spanner 7 remove the
injectors and replace them with the
ones which are necessary for the type
of gas you use (see table in "Technical
Information" chapter).
4.
Assemble the parts, follow the same
procedure backwards.
5.
Replace the rating plate (it is near the
gas supply pipe) with the one for the
new type of gas supply. You can find
this plate in the package supplied with
the appliance.
If the supply gas pressure is changeable or
different from the necessary pressure, you
must fit an applicable pressure adjuster on
the gas supply pipe.
ADJUSTMENT OF MINIMUM
LEVEL
To adjust the minimum level of the burners:
A
1.
Light the burner.
B
2.
Turn the knob on the minimum posi-
tion.
C
3.
Remove the knob.
4.
With a thin screwdriver, adjust the by-
pass screw position.
A
A)
The by-pass screw
When installation is complete,
make sure that the seal of each
pipe fitting is correct. Use a soapy
solution, not a flame!