Carp Royal Remote Controlled Bait Boat Руководство пользователя - Страница 9
Просмотреть онлайн или скачать pdf Руководство пользователя для Рыболовное оборудование Carp Royal Remote Controlled Bait Boat. Carp Royal Remote Controlled Bait Boat 13 страниц. Remote controlled bait boat
Печатать страницу
b. Powers are connected correctly and firmly, right placed and sufficient powered.
c. Control the transmitter and check the Bait Hopper according to Page 7（R.C. Channel Settings & Functions）.
d. Make propeller work by controlling the transmitter and check the LED Battery Level Monitor:
[RED] – inadequate power, need to charge main batteries.
[ORANGE] – low power, boat can run but not more than 1 hour.
[GREEN] – full power. We kindly suggest you use the boat under full power.
STEP 3. Place Baits and Fishing-lines
Close the Bait Hopper by controlling the transmitter, and put the baits and fishing-lines in.
STEP 4. Sail in Water
When the above steps finished, put the boat in water, control the transmitter and enjoy the real fun of fishing!
Attention:
a. NO sailing upon low power. Otherwise, it will cause the boat out of control in the water!
b. NO return sailing before dropping out the fishing-line, or propeller may be stuck.
c. In order to achieve the best signal control during sailing, please keep all the antennas (receiver's &
transmitter's) in same parallel direction.
STEP 5. After Sailing
After sailing, please keep your boat in order strictly according to steps below:
Close Bait Hopper by controlling the transmitter → Turn OFF Light Switch → Turn OFF Main Switch → take out
the batteries (incl. the batteries for Fish-finder Controller if have) → Turn OFF the R.C. transmitter and take out
batteries from it → (Turn OFF Fish-finder Displayer and take out batteries from it )→Clean and pack the product.
Attention: Powers should be turned OFF in following order: Light Switch → Main Switch (→Fish-finder Controller)
→ R.C. Transmitter (→ Fish-finder Displayer). Otherwise, product may be out of control, control mixing or
damaged.
Battery Charging
Attention:
a. Powers should be turned ON in this order: R.C. Transmitter → Main Switch
→ Light Switch (→Fish-finder Controller → Fish-finder Displayer).
Otherwise, product may be out of control, control mixing or damaged.
Attention:
a. Make sure powers are ON before this step.
b. Around 1kg for the Bait Hopper ONLY, otherwise the electronic
components may be damaged upon overweight.
c. Pushing the Bait Hopper Flap by hand is prohibited.
d. Group hooks should be put into the hopper from the bottom of the flap, and
with the transmitter operated at the same time so as to close the hopper and
place other baits.
When charging the main batteries, connect the two batteries at first, and
then connect batteries with the battery charger. (See Pic.)
8