Compac CBJ 5 Руководство по эксплуатации
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Джеки Compac CBJ 5. Compac CBJ 5 2 страницы. Bottle jacks
Также для Compac CBJ 5: Руководство по эксплуатации (12 страниц)
Печатать страницу
Instruction Manual
Bottle Jacks, CBJ (G2) 3 / 5 / 10 / 15 / 20 / 30 / 50 / T-10
Important: Read and understand this manual before use!
Compac would like to thank you for purchasing this product. WARNING!!! Read the instruction
thoroughly! and comprehend and follow it´s safety instructions prior to use!! It is important because
the instruction explains very substantial information about SAFETY, use and maintenance.
1. The jack is to be used only on a clean and hard level surface.
2. The load must always be on angle to the jack.
3. The pumphandle must under no circumstance be extended.
4. DO NOT!!! use the jack to lift any load which exceeds it's rated MAX. lifting capacity.!
5. Lowering/release under load: Turn the release valve (screw) slowly anti-clockwise. The
speed of decent is controlled by this valve. Abrupt or sudden release could cause danger!
6. Lift of the load out of angle is not allowed!! This could cause loss of load and cause
danger/injuries to yourself or other persons!! Use of this kind could also damage the jack
and is not covered by warranty.
7. Maintenance: When it is needed fill up with oil until the lower point of the filling hole placed
on the middle of the jack. Please note! the piston must be in the lowest position. USE
hydraulic oil ONLY!!! Store the jack vertically and clean it and lubricate with oil before and
after use.
8. At any malfunction or suspicion of this or leak of oil - DO NOT!!! use the jack!!! Contact your
dealer for service and repair.
Contents:
Drawing, Operating- and safety instruction, maintenance- and troubleshooting guide, two piece
pumping lever.
Before use:
Important! read and comprehend this instruction, because it explains very substantial information
about SAFETY, using and maintenance Afterwards! Check for defects, oil leaks, damage to the
body of the jack Check that the piston head is correctly positioned (Ref. pos. 6) Check for loose or
damaged screws or joints and check for damaged or incorrectly assembled accessories.
IMPORTANT! In case you find any damage or fault to the product, then deliver it back to your
dealer at once! without using it. The dealer will exchange the product without any charge. PLEASE
NOTE! If you find any defects the jack must be clearly labeled so it would not by mistake be used
by other persons. If you visually accept the product then please do as follows.
Operating- and safety instruction:
A. Familiarize You and your staff with the equipment. All users must for safety reasons carefully