Compac Industries Master MR40P Инструкции по установке и настройке - Страница 10

Просмотреть онлайн или скачать pdf Инструкции по установке и настройке для Диспенсер Compac Industries Master MR40P. Compac Industries Master MR40P 17 страниц.

Печатать страницу

Setting up the C4000

11.

Once the pump is connected on site, the final setup check and calibration to complete the

installation must be carried out, using the Parameter Switch and Calibration (K-Factor) Switch.

These switches are found on the C4000 Microprocessor Board which is housed in a metal

enclosure located on the left front of the unit below the display panel

Configuration Codes

11.1

The configuration code has been set at Compac and should not be changed

In the event of iit being lost and having to be re-entered the configuration is written on the

yellow label on the C4000 processor board cover.

Parameter Switch Settings

11.2

11.2.1

Setting the Pump Number

This must be set at the pump, for each hose, so that communications with

a controller can take place. The location of this switch is shown in the

diagram below.

Depress the Parameter Switch nine (9) or more times until the message

'PnA XX' appears in the litres display window. When the switch is

pressed again 'Pnb XX ' will appear on the display. These two options

will toggle each time the switch is pressed. To alter either of the pump numbers, press and hold

the Parameter Switch when the pump number to be altered appears on the display. This number

will then increment. The switch should be released when the desired pump number is displayed.

The value of the displayed number will then be stored in the C4000 memory as the pump

number for that hose.

NOTE: For a single hose only 'Pn" will appear

11.2.2

Setting the Price

Using the Parameter Switch, follow the chart to set the price for the hose(s) in question.

Step

ACTION

Ensure that the nozzle is hung up

Press and Hold the Parameter switch until the

"Price per litre" is displayed.

Press and hold the Parameter switch.

When the digit is correct, release the Parameter

switch.

Repeat steps 3 and 4 for each digit of the 'Price per

litre'.

Press and release the Parameter switch 8 or more

times in quick succession

Repeat steps 3 to 5 above.

G:\Masters\Installation Sheets\Master & Premier\MR40-80P Installation Sheet.doc

RESULT

Dispenser in idle state

The price for side 'A' is shown as 'PX.XXX' on the

litres display and 'PrA' is displayed on the money

display.

A digit, of the displayed 'Price per litre', will begin to

increment.

NOTE: the C4000 will reset itself if the Parameter

switch is left for more than 60 seconds.

Continue for Dual hose units

The price for side 'B' is shown as 'PX.XXX' on the

litres display and 'Prb' is displayed on the money

display.

Page 10 of 17