dreo DR-HSH009S Руководство пользователя - Страница 10

Просмотреть онлайн или скачать pdf Руководство пользователя для Нагреватель dreo DR-HSH009S. dreo DR-HSH009S 11 страниц. Smart wall mounted heater

Печатать страницу
TROUBLESHOOTING
Troubleshooting
Problem
Possible Causes
F1 - Outlet Fin Protection
Error
F2 - Overheat Protection
Malfunction codes on
LED display
BP - Outlet Fin Deviation
E0 - PCBA Panel
Connection Error
E1 - Temperature Sensor
Error
15
07
Solution
Wait until the heater
cools down to re-start it.
Make sure the outlet fin is
working properly.
If the problem persist,
contact Customer
Support.
Unplug and wait for it to
cool down before
plugging in again.
Make sure there are no
objects obstructing the
outlet fin, re-start the
appliance.
Do not manually adjust
the outlet fin angle.
If the problem persist,
contact Customer
Support.
Unplug it from the power
source and contact
Customer Support.
Unplug it from the power
source and contact
Customer Support.
No power is passing
through the unit.
Heater does not start
The set temperature is
lower than the ambient
temperature.
The temperature
exceeds the threshold
of the thermal cutoff.
The heater suddenly
stops during heating.
In ECO mode, the heater
will turn off
automatically when the
set temperature has
been reached.
The heater doesn't
ECO mode doesn't reach
raise temperature
my target temperature.
If your problem is not listed or still persists, contact our Customer Support (see page 17).
Remove any objects on
or near the heater.
Ensure that your circuit
breaker or fuse is
working properly.
Ensure that the
temperature is set to be
higher than the ambient
temperature.
Turn off and unplug the
unit. Allow it to cool and
plug into the electrical
outlet again.
This is normal. If your
heater turns off
frequently, please raise
the set temperature or
switch to Power Heat
mode.
If you are farther away
from your heater, you
can raise the target
temperature or switch
to Power Heat mode.
16