Electrolux 36" Ceramic Руководство по установке - Страница 7

Просмотреть онлайн или скачать pdf Руководство по установке для Вентиляционная вытяжка Electrolux 36" Ceramic. Electrolux 36" Ceramic 8 страниц. 30” and 36” free-standing range hood
Также для Electrolux 36" Ceramic: Руководство по эксплуатации и уходу (26 страниц), Руководство по установке (7 страниц), Руководство по установке, использованию и уходу (22 страниц), Руководство по установке (25 страниц)

Печатать страницу

GAS COOKTOP INSTALLATION INSTRUCTIONS

Checking Operation

Refer to the Use and Care Guide packaged with the

cooktop for operating instructions and for care and

cleaning of your cooktop.

Do not touch the burners. They may be

hot enough to cause burns.

1. Install Burner Caps

This cooktop is equipped with sealed burners as

shown (see Figure 8).

A. Unpack your burner heads and burner caps.

B. Place burner head over each gas orifice,

matching the head with the orifice size. Be

careful not to damage the electrode while

placing the head over the orifice. Make sure

electrode fits correctly into slot in burner head.

C. Place a burner cap on each burner head,

matching the cap size to the head size. Each

burner cap has an inner locating ring which

centers the cap correctly on the burner head.

D. Be sure that all the burner caps and burner

heads are correctly placed BEFORE using your

cooktop.

Burner Cap

Cooktop Surface

Burner Head

Electrode

Figure 8

NOTE: There are no burner adjustments necessary on

this cooktop.

(For 36" Models with 6 Sealed Burners)

2. Turn on Electrical Power and Open Main Shutoff

3. Check the Igniters

4. Adjust the "LO" or "SIMMER" Setting of Surface

Gas Opening

Gas Valve

Operation of electric igniters should be checked after

cooktop and supply line connectors have been

carefully checked for leaks and the cooktop has

been connected to electric power.

To operate the surface burner:

A. Push in and turn a surface burner knob to the

LITE position. You will hear a ticking noise; this

is the sound of the electric ignitor which lights

the burner.

B. After the burner lights, turn to the desired flame

size. The controls do not have to be set at a

particular mark. Use the marks as a guide and

adjust the flame as needed.

Burner Valves (see Figure 9)

Push in and turn each control knob to the "LO" (or

"SIMMER") setting. The "LO" setting of each

burner has been set at the factory to the lowest

setting available to provide reliable reignition of the

burner. If it does not stay lit on the "LO" setting,

check the setting as follows.

Be careful when performing this

operation.

A. Allow cooktop to cool to room temperature.

B. Light all burners by turning each control knob to

LITE until burners ignite, and then set them at

"HI".

C. Quickly turn the knob to the LOWEST POSITION.

D. If burner goes out, readjust valve as follows:

Remove the surface burner control knob, insert a

thin-bladed screw driver into the hollow valve

stem and engage the slotted screw inside. Flame

size can be increased or decreased with the turn

of the screw. To increase flame size turn the

screw counterclockwise and to decrease turn

clockwise. Adjust flame until you can quickly

turn knob from HI to LOWEST POSITION without

extinguishing the flame. Flame should be as

small as possible without going out.

E. If you need to adjust another burner, repeat the

steps from A to D above until all burners operate

properly.