Electrolux AEG DD9663-M Инструкции по эксплуатации и установке - Страница 8

Просмотреть онлайн или скачать pdf Инструкции по эксплуатации и установке для Вентиляционная вытяжка Electrolux AEG DD9663-M. Electrolux AEG DD9663-M 17 страниц.

Печатать страницу

Alarm signal reset

• Turn the Lights and the Suction motor off.

• Press button H and hold for at least 2 seconds,

confirmation is provided by the fact that the Led goes

out.

Before carrying out any maintenance or

cleaning isolate the cooker hood from the

mains supply.

Charcoal Filters

In the recirculation mode the charcoal filters absorb smells

and unwanted odours.

This filter cannot be washed or regenerated, and must be

replaced when the Led on Button H starts to flash, or at

least every 4 months. The alarm can only be seen when

the Suction motor is turned on.

Enabling/Disabling the alarm signal

• For Recirculation Version Hoods, the Filter satura

tion alarm must be enabled on installation or at a

later date.

• Turn the Lights and the Suction motor off.

• Press button H and hold for at least 5 seconds until

the Led gives confirmation as follows:

• Led flashes twice - Activated Charcoal Filter

Alarm ENABLED.

• Led flashes once - Activated Charcoal Filter

Alarm DISABLED.

To Remove the Charcoal Filters

• Open the glass panel on the hood by pulling down-

wards.

• Remove the saturated activated charcoal filters as

shown (A).

• Fit the new filters, as indicated (B).

• Close the glass panel.

This appliance can be a possible fire hazard if

the grease and charcoal filters are not cleaned

and replaced as recommended.

MAINTENANCE AND CLEANING