Electrolux CH 950X Книга инструкций - Страница 8

Просмотреть онлайн или скачать pdf Книга инструкций для Вентиляционная вытяжка Electrolux CH 950X. Electrolux CH 950X 21 страница. Electrolux cooker hood instruction manual

Печатать страницу

Before carrying out any maintenance or cleaning isolate the cooker hood from the mains supply.

Charcoal Filters

In the recirculation mode the charcoal ﬁ lters absorb smells and unwanted odours.

Enabling the alarm signal

• In Recirculation version Hoods, the Filter saturation alarm can be enabled on installation or at a later date.

• Turn the Lights and the suction Motor off.

• Disconnect the Hood using the Main switch or the double-pole switch on the mains power supply.

• Restore the connection by pressing and holding T1.

• Release the button. All ﬁ ve LEDs are turned on

• Within 3 seconds press T1 until LEDs T1 and T4 ﬂ ash in conﬁ rmation:

• LED ﬂ ashes twice - Activated charcoal ﬁ lter saturation alarm ENABLED

• LED ﬂ ashes once - Activated charcoal ﬁ lter saturation alarm DISABLED

The ﬁ lter is not washable and cannot be regenerated. It must be replaced when led S1 ﬂ ashes or at least every

4 months. The alarm signal will only light up when the extractor motor is switched on.

To Remove/Replace the Charcoal Filters

• Remove the metal grease ﬁ lters

• Remove the saturated activated carbon ﬁ lter by

releasing the ﬁ xing hooks

• Fit the new ﬁ lter by hooking it into its seating

• Replace the metal grease ﬁ lters.

This appliance can be a possible ﬁ re

hazard if the grease and charcoal ﬁ lters

are not cleaned and replaced as recommended.

Alarm signal reset

• Switch off the lights and extractor motor.

• Press button T3 for at least 3 seconds, until the

leds start to ﬂ ash.

Changing the Light halogen

• Remove the snap-on lamp cover by levering it from

under the metal ring, supporting it with one hand.

• Remove the halogen lamp from the lamp holder by

pulling gently.

• Replace the lamp with a new one of the same type,

making sure that you insert the two pins properly into

the housings on the lamp holder.

• Replace the snap-on lamp cover.

MAINTENANCE AND CLEANING