Dri-Air Industries HP4-X 18-100 Руководство по эксплуатации - Страница 10

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Контроллер Dri-Air Industries HP4-X 18-100. Dri-Air Industries HP4-X 18-100 20 страниц. Floor mount dryers

Печатать страницу

INSTALLATION

PROCEDURE

Page 10

DRI-AIR

For all Dri-Air models except ARID-X 10, AHM-1, & PDII

Electrical Connection:

Open electrical access door on the front of the machine by

turning the disconnect off and turning the lower clamping

screw 1/2 turn counterclockwise. Locate the disconnect by

following the operating handle down to the electrical panel.

Insert the incoming power cable or conduit through the hole

provided on the side of the machine.

« use approved wire and fastening means «

Wire incoming power to the top of the disconnect as shown in

the diagrams below.

NOTE:

When 3 wire supplies are used in place of 4 wire supplies,

a control transformer is required.

3 PHASE DRYER INSTALLATION

CHECK FOR CORRECT MOTOR ROTATION

BEFORE RUNNING DRYER

To check motor rotation.......

Leave the electrical cabinet door open so the blower can be

observed. Turn on the power to the dryer and press the ON/

START touch pad and then immediately press the OFF/STOP

touch pad. Observe the cooling fan on the top of the blower

motor and verify the fan is turning clockwise. If the motor is

not turning clockwise, switch any two adjacent supply wires.

The unit is now ready for operation.

OPERATING MANUAL - ARID-X , HP4-X 18-100 FM DRYERS

Revision 10/8/02

INDUSTRIES, INC.