Atlantic Technology ICTS-6.1 Инструкции по установке - Страница 2
Просмотреть онлайн или скачать pdf Инструкции по установке для Динамики Atlantic Technology ICTS-6.1. Atlantic Technology ICTS-6.1 2 страницы. Ceiling speakers
Печатать страницуNew Construction and Retrofit Installations
Note: A new construction rough-in kit and back box kit are optionally
available from Atlantic Technology. Please refer to the instructions included
in those kits for their use. If the rough in kit has been used please go directly
to Step 2 below.
Mounting Hole Specifications:
ICTS-6.1: Diameter = 7
⁄
in., 188mm; Depth = 4
3
8
1
Cut an appropriately sized opening in the ceiling material. Be sure that the
ceiling material can support the weight of the speaker. Also be sure that
the sides of the opening are at least 1 ½ inches away from any beams or
studs within the cavity. If it is not, the rotating clamps will be restricted
in their movement and may not clamp properly.
Figure 1
No less than 1 ½"
Joist
or Stud
2
Be sure that all foreign material in the ceiling is kept out of the speaker
assembly, particularly the back of the woofer cone. There is a cloth shield
on the rear of the woofer, but please use care anyway.
3
For conventional Connection to an audio amplifier/receiver:
Attach the speaker wires that have been already run through the ceiling
to the speaker terminals. Simply remove ½ inch of insulation from the
end of each input wire. Push down on the terminal connector and an
opening will appear in the connector that is capable of holding up to 14
gauge wire. Insert the bare wire into the opening and release the terminal.
Be sure to observe correct polarity, connecting the positive (+) leads to
the red terminals and the negative (-) leads to the black terminals. Also
be sure that no stray strands of wire touch across any terminals. See
Figure 2.
Figure 2
⁄
in., 118mm
5
8
Joist
or Stud
For Connection to an IP-type system, like NetStreams®:
Unscrew the 4 setscrews
on top of the built-in
Phoenix connector and
pull the wires away from
the connector. See Figure
3 (You may tie or clip the
wires that used to connect
here.)
Connect the wires from
the NetStreams amplifier
to the ICTS-6.1's Phoe-
nix connector and screw
down tightly. Consult your
NetStreams manual for
wiring details.
4
Mount the speaker in the ceiling.
Tighten the mounting screws one at a time. As you tighten the screws,
the clamps on the back of the assembly will turn and lower, grabbing
the back of the ceiling and sandwiching the ceiling between themselves
and the frame's circular trim ring.
5
Snug all four mounting screws in this manner. Be careful not to over-
tighten them.
IMPORTANT: If you are using an electric screwdriver, make sure it is
set to the "low torque" position.
6
You may now install the grille into the frame by gently pushing it into
the recess.
Figure 4
Ceiling
Atlantic Technology
343 Vanderbilt Avenue Norwood, MA 02062
(781) 762-6300 www.atlantictechnology.com
Grille
Figure 3
015-1061