Dri-Eaz CMC100 Руководство пользователя - Страница 3

Просмотреть онлайн или скачать pdf Руководство пользователя для Осушитель Dri-Eaz CMC100. Dri-Eaz CMC100 6 страниц. Dri-eaz cmc100 dehumidifier
Также для Dri-Eaz CMC100: Руководство пользователя (4 страниц)

Печатать страницу

Fig. 3: Parts Identification

Condensate

drain outlet

Leveling foot-

pads (one on

each corner)

OPERATION

Plug in the power cord into a standard 115V grounded

outlet. The unit must be operated on a 115V/60 Hz circuit

protected by a Ground Fault Interrupter (GFI) device.

Attach one end of the drain hose to the condensate drain

outlet and directing the other end into a drain or away from

area to be kept dry. NOTICE: To prevent CMC100 drain

pan overflow, ensure that there are no kinks or sharp

bends in the drain hose and do not place the outlet of the

hose higher than 3 ft. (1 m) above the top of the CMC100.

The CMC100 is controlled by an electronic touchpad hu-

midistat. The unit will automatically start when the humidity

of the surrounding air exceeds the humidity level selected.

Set humidity set point with Control Panel (see below).

CONTROL PANEL

ON/STANDBY button

The ON/STANDBY button toggles the unit between the ON

and STANDBY modes. The display indicates the current mode.

In the ON mode, the display shows the current measured

humidity as a percentage of relative humidity.

07-01637F F391-A 2012-01 Warranty 07-01651

Interchangeable pa-

nels. See Optional

Configurations, p. 2.

Processed air

outlet

Indicates normal

operating condi-

tions.

Display

ON/STANDBY

button

UP/DOWN

buttons

ON mode display

shows current hu-

midity

To view the current humidity setting, first set the unit in

the ON mode, and then press the UP or DOWN arrow

once.

UP button

To change the humidity setting, press the UP or DOWN

button twice. Each time you press the button, the value of

the humidity setting will increase or decrease in 5 percent

increments.

Note: In the ON mode, the display will show the humidity

setting only when you press the UP or DOWN buttons. Af-

ter you have finished adjusting the setting, the display will

resume indicating the measured humidity and the CMC

will automatically maintain humidity at the selected setting.

In the STANDBY mode, the display shows a double dash.

Unit does not operate in this mode. Press the

ON/STANDBY button to return to ON mode.

Note: The UP and DOWN buttons do not function in the

Stand-by Mode. Press the ON/STANDBY button to

resume operation.

ADDITIONAL MODES

The CMC100 also has a DEFROST mode and a LOW TEM-

PERATURE PROTECTION mode. The unit automatically in-

itiates these modes as conditions warrant. No user intervention

is required.

The CMC will automatically enter the DEFROST mode as

needed. The fan will continue to operate until the unit is

ready for the next operating cycle. The unit will automati-

cally return to ON mode when the defrost cycle is com-

plete.

When the ambient temperature falls below 45°F (7°C), the

unit enters LOW TEMPERATURE PROTECTION mode

and stops operating. The unit will automatically restart

when the surrounding temperature rises above freezing.

Automatic water pump out

The unit automatically pumps out condensate through the con-

densate drain hose. No user intervention is required.

Note: Check for proper operation before leaving the unit unat-

tended. Do not move the CMC100 while it is operating.

DOWN button

STANDBY mode

DEFROST Mode

LOW TEMPERATURE PRO-

TECTION Mode

Dri-Eaz Products, Inc.