Atlantic Technology 4.5 PBM Руководство по эксплуатации - Страница 11

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Сабвуфер Atlantic Technology 4.5 PBM. Atlantic Technology 4.5 PBM 13 страниц. High performance powered subwoofer
Также для Atlantic Technology 4.5 PBM: Руководство по эксплуатации (12 страниц)

Печатать страницу

1. Connecting Your Subwoofer

The 4.5 PBM has an elegant Gloss Black top panel. Special adhesive tape has been employed that is

designed to hold the top firmly to the cabinet, yet allow release without damage. Should you wish,

you may remove the gloss top by carefully pulling it up and away from the enclosure. Under the gloss

panel, the top of the enclosure is finished in the same Black Oak laminate as the rest of the enclosure.

You should use care when cleaning the Gloss Black top. Use a soft natural fiber cloth (not paper

products, as they can scratch) slightly dampened with water. You may also use any of the specially

formulated plastic polishes available on the market, should you desire.

NOTE: The Gloss Black top is shipped with a protective paper layer attached. In order to remove this paper

layer begin peeling it up at one corner and gently and carefully pull the paper off at a sharp angle so as not

to pull the top itself from the cabinet.

Avoid placing your speakers in direct sunlight or near a source of heat that may, over time, damage the

finish.

Important: Save Your Boxes! If you can do so, save the carton, packing pieces and plastic bags that

came with your subwoofer. They will be useful in case you move or have to ship your subwoofer for any

reason. In any case, save all packing materials until you are certain that the system has suffered no damage

in shipment. If you find such damage, either visible or internal, contact your dealer immediately for the proper

return procedure.

Subwoofer Troubleshooting Guide

Once your subwoofer is set up, you should have many years of maintenance free enjoyment from your

system. However, if you should encounter a problem, refer to the following guide to help find the

solution. If the problem persists, please contact your local authorized Atlantic Technology dealer.

Problem

No bass output

Audible buzz

or hum

More than one

source audible

Weak bass

Weak bass: vague stereo image

Possible Cause

AC power cord unplugged or plugged into a non-working outlet.

Input cables not securely connected or defective.

Input cable not securely connected or defective.

Single HI LEVEL input connected to the RIGHT channel only.

Ground loop through antenna or cable TV system input.

More than one source is playing.

Subwoofer too far from the wall.

VARIABLE INPUT LEVEL set too low.

Input source connected to HI LEVEL inputs is wired out of phase.

Possible Solution

Plug into a working outlet.

Check all connections, then try another input cable.

Connect to the LEFT input channel.

Test by disconnecting antenna and/or cable system input leads.

If hum goes away, install isolation balun(s) at that point.

All the subwoofer's inputs are active at all times. Turn off

unwanted source.

Move the subwoofer closer to a wall or corner.

Turn control up somewhat.

Check speaker wire connections and reconnect in proper phase.

Atlantic Technology