Electrolux RH30WC40GS Руководство по установке, использованию и уходу - Страница 12
Просмотреть онлайн или скачать pdf Руководство по установке, использованию и уходу для Вентиляционная вытяжка Electrolux RH30WC40GS. Electrolux RH30WC40GS 19 страниц. Universal/multiflex
Также для Electrolux RH30WC40GS: Брошюра и технические характеристики (2 страниц), Заводской каталог деталей (4 страниц)
Installing the hood
12
12
12
12
12
Step 15
Step 15
Step 15
Step 15
Step 15
WIRING THE HOOD
WIRING THE HOOD
WIRING THE HOOD
WIRING THE HOOD
WIRING THE HOOD
Electrical Shock Hazard
Warning: Turn off power at the service panel before
wiring this unit.
120 VAC, 15 or 20 Amp cir
120 V
120 V
AC, 15 or 20 Amp cir
AC, 15 or 20 Amp circuit r
AC, 15 or 20 Amp cir
120 V
120 V
AC, 15 or 20 Amp cir
ELECTRICAL GROUNDING INSTRUCTIONS
ELECTRICAL GROUNDING INSTRUCTIONS
ELECTRICAL GROUNDING INSTRUCTIONS
ELECTRICAL GROUNDING INSTRUCTIONS
ELECTRICAL GROUNDING INSTRUCTIONS
THIS APPLIANCE IS FITTED WITH AN ELECTRICAL
JUNCTION BOX WITH 3 WIRES, ONE OF WHICH
(GREEN/YELLOW) SERVES TO GROUND THE
APPLIANCE. TO PROTECT YOU AGAINST
ELECTRIC SHOCK, THE GREEN AND YELLOW
WIRE MUST BE CONNECTED TO THE
GROUNDING WIRE IN YOUR
HOME ELECTRICAL SYSTEM, AND IT MUST
UNDER NO CIRCUMSTANCES BE CUT OR REMO-
VED.
Failure to do so can r
Failur
Failur
e to do so can r
e to do so can r
e to do so can result in death or electrical
Failur
Failur
e to do so can r
shock.
shock.
shock.
shock.
shock.
• If not already done, install 1/2" conduit connector
in j-box.
• Run black (live), white (neutral), and green (earth)
wires (#14 AWG) according to the National
Electrical Code or CSA Standards and local
codes and ordinances in 1/2" conduit from power
supply to j-box.
• Connect black, white, and green wires from
power supply to black, white, and green/yellow
wires in j-box respectively.
• These connections should be done always
making reference to the electrical diagram found
inside the hood.
• Close j-box cover.
Step 16
Step 16
Step 16
Step 16
Step 16
Final installation steps
Final installation steps
Final installation steps
Final installation steps
Final installation steps
Replace filters and install the lamps as described in
the Care & Use section of this manual.
Note:
Note:
Note:
Note:
Note: Lamps are not supplied, use ONLY 120 Volt,
50 Watt (maximum) 50° halogen light made for a
GU10 base, suitable for use in open luminarie
Turn power on at service panel.
Check operation of the hood.
IMPORTANT: If the hood doesn't switch ON, before
calling for service, check if the internal General ON/
OFF Pushb-utton Switch is switched ON.
cuit r
cuit requir
cuit r
equir
equir
equired.
ed.
ed.
ed.
cuit r
equir
ed.
esult in death or electrical
esult in death or electrical
esult in death or electrical
esult in death or electrical
suitable for use in open luminarie
suitable for use in open luminarie
suitable for use in open luminarie
suitable for use in open luminarie.
General ON/OFF
Push button Switch
Back side of the hood
Front side of the hood