Bosch 6 Series Инструкция по установке и использованию - Страница 17

Просмотреть онлайн или скачать pdf Инструкция по установке и использованию для Пылесос Bosch 6 Series. Bosch 6 Series 20 страниц. 2 door top freezer, inox-easyclean
Также для Bosch 6 Series: Руководство пользователя (24 страниц), Инструкция по установке и использованию (20 страниц), Инструкция по установке и использованию (20 страниц), Руководство по эксплуатации и инструкции по установке (48 страниц), Руководство по эксплуатации (16 страниц), Руководство по эксплуатации (48 страниц), Руководство по установке (27 страниц), Руководство по эксплуатации (12 страниц), Руководство по установке и эксплуатации (36 страниц), Руководство по эксплуатации (16 страниц), Инструкция по установке и использованию (16 страниц), Руководство по эксплуатации (29 страниц), Руководство пользователя и инструкция по установке (16 страниц), Информация для использования (32 страниц), Краткое справочное руководство (2 страниц), Краткое справочное руководство (2 страниц), Информация для использования (28 страниц), Руководство пользователя (23 страниц), Руководство по эксплуатации (24 страниц), Инструкции по установке и инструкции по эксплуатации (24 страниц), Информация для использования (16 страниц), Руководство пользователя (36 страниц), Руководство пользователя (32 страниц), Руководство пользователя (28 страниц), Руководство пользователя (28 страниц), Руководство по эксплуатации (28 страниц), Информация для использования (20 страниц), Руководство по эксплуатации (28 страниц)

Печатать страницу
Bosch 6 Series Инструкция по установке и использованию
KGeneral information
E xhaust air mode
G e n e r a l i n f o r m a t i o n
:
Warning – Risk of death!
Risk of poisoning from flue gases that are drawn back
in. The exhaust air must not be conveyed into a
functioning smoke or exhaust gas flue or into a shaft
which is used to ventilate installation rooms that contain
heating appliances. If the exhaust air is to be conveyed
into a non-functioning smoke or exhaust gas flue, you
must obtain the consent of the heating engineer
responsible.
If the exhaust air is conveyed through the outer wall, a
telescopic wall box should be used.
Exhaust duct
The device manufacturer does not assume any
Note:
warranty for complaints attributable to the pipe section.
The device achieves its optimum performance by
■
means of a short, straight exhaust air pipe and as
large a pipe diameter as possible.
As a result of long rough exhaust air pipes, many
■
pipe bends or pipe diameters that are smaller than
150 mm, the optimum extraction performance is not
achieved and fan noise is increased.
The pipes or hoses for laying the exhaust air line
■
must consist of non-combustible material.
Round pipes
An inner diameter of 150 mm, but at least 120 mm, is
recommended.
Flat ducts
The inner cross-section must correspond to the
diameter of the round pipes.
dia. 150 mm ca. 177 cm
dia. 120 mm ca. 113 cm
Flat ducts should not have any sharp deflections.
■
Use sealing strips for deviating pipe diameters.
■
2
2
Checking the wall
The wall must be level, vertical and adequately load-
■
bearing.
The depth of the bore holes must be the same
■
length as the screws. The wall plugs must have a
secure grip.
The enclosed screws and wall plugs are suitable for
■
solid brickwork. Suitable fasteners must be used for
other structures (e.g. plasterboard, porous concrete,
poroton bricks).
The max. weight of the extractor hood is 40 kg.
■
Electrical connection
:
Warning – Risk of electric shock!
Components inside the appliance may have sharp
edges. These may damage the connecting cable. Do
not kink or pinch the connecting cable during
installation.
The required connection data can be found on the
rating plate inside the appliance; to do this, remove the
metal mesh grease filter.
Length of the cable: approx. 1.30 m
This appliance complies with the EC interference
suppression regulations.
:
Warning – Risk of electric shock!
It must always be possible to disconnect the appliance
from the electricity supply. The appliance must only be
connected to a protective contact socket that has been
correctly installed.
The mains plug of the mains power cable must be
easily accessible after installation of the appliance. If
this is not possible, an all-pole isolating switch must be
integrated into the permanent electrical installation
according to the conditions of overvoltage category III
and according to the installation regulations.
The permanent electrical installation must only be wired
by a professional electrician. We recommend installing
a residual-current circuit breaker (RCCB) in the
appliance's power supply circuit.

General information

en
17