Electrolux Beam Руководство по установке - Страница 15

Просмотреть онлайн или скачать pdf Руководство по установке для Пылесос Electrolux Beam. Electrolux Beam 16 страниц. Central

SHARP 90° BEND: behind every inlet

The sharp 90° bend is an anti-blocking device, rather like the u-bend

under a sink - this MUST be located immediately behind all inlets

(including VacPans) to stop anything that could block-up the system. Any

debris that can't get past is then easily extracted by opening the inlet and

hooking it out.

Occasionally, if you are putting the pipe through a solid wall, it will not be

possible to position the sharp 90° bend right behind the inlet, in which

case it should be the first bend on the other side of the wall.

There are also rare situations where the plasterers have been a little too

generous with the plastering and the inlet won't reach the mounting

plate. You may therefore need to order an inlet valve extension from us

(code 2020) to fit into the mounting plate before you can fix the inlet on

the wall satisfactorily.

FIRST FITTING TO BE BEHIND INLET

Sharp 90°

Bend

NEVER

BEHIND AN INLET

YOU WON

NB: I

F THIS BEND IS PUT ELSEWHERE IN THE SYSTEM

AGAINST BLOCKAGES WILL BE MADE INVALID

RULE 5

Sweep 45°

90°B

LOCATE A SHORT

. A

S AN ANTI

T BE ABLE TO HAVE ACCESS TO CLEAR A BLOCKAGE

Bend

END ANYWHERE ELSE IN THE DUCT RUN APART FROM

BLOCKING DEVICE DEBRIS MAY BE STOPPED HERE AND

Sweep 90°

Bend

THE LIFETIME GUARANTEE