Drill Master DrillMaster 68287 Руководство пользователя - Страница 9
Просмотреть онлайн или скачать pdf Руководство пользователя для Сверло Drill Master DrillMaster 68287. Drill Master DrillMaster 68287 15 страниц. 18v cordless drill/flashlight set
Также для Drill Master DrillMaster 68287: Руководство (13 страниц)
Печатать страницу
3. When storing, always store in clean, dry and
safe location out of reach of children.
Troubleshooting
Problem
Tool will not start.
1. No power at outlet during
2. Internal damage or
Performance
1. Accessory dull or damaged.
decreases over time.
2. Carbon brushes worn
Excessive noise
Internal damage or wear. (Carbon
or rattling.
brushes or bearings, for example.)
Overheating.
1. Forcing tool to work too fast.
2. Accessory misaligned.
3. Accessory dull or damaged.
4. Blocked motor housing vents.
Overheating.
1. Forcing tool to work too fast.
2. Accessory misaligned.
3. Accessory dull or damaged.
4. Blocked motor housing vents.
Follow all safety precautions whenever diagnosing or servicing the tool. Disconnect power supply
before service.
SKU 68287
Possible Causes
charging.
wear. (Carbon brushes or
switch, for example.)
or damaged.
For technical questions, please call 1-800-444-3353.
4.
WARNING! If the supply cord of this power
tool's charger is damaged, it must be replaced
only by a qualified service technician.
Likely Solutions
1. Check power at outlet. If outlet is unpowered,
turn off tool and check circuit breaker. If breaker
is tripped, make sure circuit is right capacity
for tool and circuit has no other loads.
2. Have technician service tool.
1. Keep accessories sharp. Replace as needed.
2. Have qualified technician replace brushes.
Have technician service tool.
1. Allow tool to work at its own rate.
2. Check and correct accessory to fence
and/or table alignment.
3. Keep cutting accessories sharp. Replace as needed.
4. Wear ANSI-approved safety goggles and NIOSH-
approved dust mask/respirator while blowing
dust out of motor using compressed air.
1. Allow tool to work at its own rate.
2. Check and correct accessory to fence
and/or table alignment.
3. Keep cutting accessories sharp. Replace as needed.
4. Wear ANSI-approved safety goggles and
NIOSH-approved dust mask/respirator while
blowing dust out of motor using compressed air.
Page 9