Bose 151 Руководство пользователя - Страница 5

Просмотреть онлайн или скачать pdf Руководство пользователя для Динамики Bose 151. Bose 151 19 страниц. Environmental
Также для Bose 151: Руководство пользователя (12 страниц), Руководство по эксплуатации (11 страниц)

Печатать страницу

• Regardless of where you place your

speakers, make sure they cannot fall and

cause injuries See "Accessories" on

page 8

•

Bose 151

speakers are not magnetically

shielded Keep them at least 9 inches

(23 cm) from any video screen or

monitor

Note: Magnets in the speakers will affect

boat compass Consider this in choosing

speaker location, or make sure to correct for

this deviation

• On a boat, you can surface mount the

speakers or mount them flush to the

bulkhead (Refer to "Accessories" on

page 8)

Note: To flush-mount 151 speakers in

boat, you must cut

hole in the bulkhead for

each speaker You may want to consult

marine electronics installer (employed by

most boat yards) before cutting any holes

Unpack the speakers

Unpack each speaker carefully Save the

carton and packing materials for possible

later use If either speaker appears dam-

aged, do not operate either one Repack

both speakers in the original carton and

notify your authorized Bose dealer immedi-

ately

How to hook up Bose®

151 speakers

CAUTION: Before making any connections,

turn off your receiver or amplifier and unplug

it from the outlet (the AC power mains)

Choose the

speaker cord

Be sure to use the proper gauge (thickness)

of speaker cord Standard zip cord (2-

conductor, 18-gauge wire found at electrical

and hardware stores) works for most

applications If your speakers will be more

than 30 feet (9 m) from the receiver or

amplifier, see the wire recommendations

under "Technical information" on page 11

Or check with your authorized Bose dealer

If you decide to run the speaker cord

through a wall or underground, check your

local building code requirements, or contact

an electrical installer before proceeding

Note: Be sure to cut enough cord to reach

from the receiver to each speaker