Bose 151 SE Руководство пользователя - Страница 5

Просмотреть онлайн или скачать pdf Руководство пользователя для Динамики Bose 151 SE. Bose 151 SE 17 страниц. Environmental speaker

Figure 5

Adjusting speaker angle

Connecting your speakers to your receiver/amplifier

Figure 6

Speaker wiring

The Bose

6. Secure the speaker with bracket part B to bracket part A using bracket locking screw C

and lock washer D (Figure 3). To adjust the angle, loosen screw C slightly (Figure 5),

move the speaker up or down, and retighten screw C.

Note: Your 151

SE speakers can be mounted vertically. However, when mounted vertically you

will not experience Stereo Everywhere

Note: For vertical mounting, mount bracket part A so that the hole for bracket locking screw C is

at the lower end of the bracket. When mounted vertically, you can rotate the logo to be read hor-

izontally. Gently pull out on the logo, rotate it into position and release.

Speaker cord consists of two insulated wires. The wire marked with a stripe or rib is used

for the positive (+) red terminal connection. The plain wire is used for the negative (–) black

terminal connection. Strip approximately ½ inch (1.3 cm) of insulation from the ends of both

wires (Figure 6). Then, twist the ends of each wire so there are no loose strands.

CAUTION: Before making any connections, turn off your receiver/amplifier and unplug it from

the AC power outlet.

1. At the back of your speaker (Figure 6), unscrew the hex knobs on the terminal posts until

you can see the small hole going through each post.

2. Insert the marked (+) wire into the red (+) terminal. Insert the plain (–) wire into the black

(–) terminal. Tighten the knobs to secure the wires.

3. Check the speaker connections carefully. Make sure no loose strands of wire touch

across terminals creating a short circuit that can damage an amplifier or receiver.

Note: After making the connections, any bare lengths of speaker wire can be affected by expo-

sure to the outdoor environment. To protect the speaker wires, apply a thin coating of silicone

caulking material, such as RTV adhesive, to any bare sections of speaker wire.

151

SE Environmental Speakers

speaker performance.

Rear of speaker

½ inch

(1.3 cm)

(+) Wire

(+) Terminal