Atlas Copco PHE50H Инструкции по ремонту - Страница 12
Просмотреть онлайн или скачать pdf Инструкции по ремонту для Сверло Atlas Copco PHE50H. Atlas Copco PHE50H 15 страниц.
Печатать страницу
1
Mounting
Insert the complete spindle sleeve with
the crank
piston and connecting rod (6) into the gear
box (5).
2
Insert the complete crank (2) into the gear
housing (3) from below and hang it in the
connecting rod.
3
Insert the locking ring (1) with aid of spe-
cially cut pliers between toothed wheel
and gear housing (3).
4
Cover the screws (4) with locking agent.
Put the flange (5) onto the gear box (3)
and fasten it with the screws (4) (tighten-
ing moment = 10 Nm).
5
Through the opening, fill in the gear
box (3) with grease according to the
lubrication chart.
6
Fit the service cap (8) with the gasket (7),
mount four washers (9), and fasten the serv-
ice cap (8) with the four nuts (A) (tightening
moment = 3 Nm).
7
Fit the anti-vibration plate spring (B) to the
gear box (3) and fasten it with the secured
screws (C) (tightening moment = 5 Nm).
1
Mounting the
Press the needle bearings (3) and (6) into
gear box cover
the gear box cover (7).
2
Insert the seal ring (8) and the O-ring (1)
into the gear box cover (7).
3
Lightly cover the seal ring (4) with blue
grease and insert it.
4
Fit the gear box cover (7) and the gas-
ket (4) to the gear box (5).
5
Apply screw locking device to the
screws (2) and fasten them (tightening
moment = 3 Nm).
Take care that the toothing of the spin-
dle sleeve and the toothing of the gear
wheel work into each other.
The locking ring (1) must cover the bor-
ing (D) (dotted line) to avoid the escap-
ing of any grease.
Repair Instructions No.184.11/98
4
5 6
3
2
1
3
4
3
2
1
PHE 50 H
8
9
A B
C
7
F
D
2
1
5
6
7
8
PAGE
11
6
7