Atlas Copco PB 14 C Краткое руководство по эксплуатации - Страница 2

Просмотреть онлайн или скачать pdf Краткое руководство по эксплуатации для Инструменты Atlas Copco PB 14 C. Atlas Copco PB 14 C 11 страниц.

Dismantling the

Remove the catcher housing (8), the

anvil assembly

rubber ring (7), and the recoil absorber (6)

from the anvil housing (2).

Expel the anvil (4) together with the recoil

ring (5) from the housing (2) by hitting it

lightly with a hammer.

Remove the location ring (10) and the

O–rings (11 and 12) from the hammer

case (13).

Remove the O–ring (9) from the anvil

housing (2), place this upon a press table,

and press the liner (1) from the housing

using a mandrel.

Only remove the liner if it is damaged or

badly worn. Only let authorized personnel

with proper tools remove the liner.

Removing the

Remove the six Allen screws (1) together

hammer case

with the washers.

Remove the hammer case (2) from the

bearing housing (3).

Attention! Make sure you lose no parts that

might fall from the machine!

Removing the

Pull the complete inclined shaft bearing

inclined shaft

assembly (5) from the hammer case (1).

bearing

Remove the outer ring (6) from the

assembly

inclined shaft bearing assembly.

Remove the outer ring (4), the washer (3),

as well as the eight disc springs (2) from

the hammer case (1).

In case that the outer ring is stuck in the

hammer case, unscrew and remove the

edn cap (7) and press the ring out from

this side.

Repair instruction No. 171.5/94

PB 14 D, PB 14 C

3 4

8 9

PAGE